User manual HOTPOINT KIA 630 C

[. . . ] 1 INCREASE POWER button switches on the hotplate and controls the power (see Start-up and use). 2 REDUCE POWER button controls the power and switches off the hotplate (see Start-up and use). 3 COOKING ZONE SELECTOR indicator shows a particular cooking zone has been selected and therefore various adjustments are possible. 4 COOKING ZONE SELECTOR button is used to select the desired cooking zone. [. . . ] Adjust the power level of the cooking zone. Or button is pressed for an extended period of time, the display scrolls quickly though the power levels and timer minutes. Press the The indicator light corresponding to the selected zone will start flashing. Set the cooking duration using the buttons. - + and The timer begins counting down immediately. When the time has elapsed, a buzzer will sound (for one minute). Confirm by pressing the selection occurs after 10 seconds. The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other button programmed hotplates, press the repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. Changing the programme button repeatedly until the duration 1. Use the buttons to set the new duration. Control panel lock When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during button to lock the control cleaning, etc. Press the panel: the indicator light above the button will switch on. To stop cooking), you button for a must switch off this function. Press the few moments, the indicator light will switch off and the lock function will be removed. Switching off the hob Press the button to switch off the appliance - do not rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. [. . . ] Do not use abrasive or corrosive detergents should be carried out while the appliance is warm (not hot) or cold. € Always remember to rinse the appliance well with clean water and dry it thoroughly: residues can become encrusted during subsequent cooking processes. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. [. . . ]