User manual HOTPOINT KIO 632 C C S

[. . . ] € WARNING: The appliance and its accessible parts become hot during use. € Care should be taken to avoid touching heating elements. € Children less than 8 years of age shall be kept away unless continuously supervised. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] Adjust the power level of the cooking zone. Press the light corresponding to the selected zone will start flashing. Or button is pressed for an extended period of time, the display scrolls quickly though the power levels and timer minutes. - + Switching on the hob To switch the hob on, press and hold the approximately one second. Set the cooking duration using the buttons. - + and Control panel lock When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, button to lock the control panel: etc. Press the the indicator light above the button will switch on. To stop cooking), you button for a must switch off this function. Press the few moments, the indicator light will switch off and the lock function will be removed. Confirm by pressing the button or automatic selection occurs after 10 seconds. The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. 15 GB The FlexiZONE mode The FLEXI Zone can be used to set the power of two „interconnected” hotplates to the same level. It can be activated if the two hotplates are OFF, by pressing the FLEXI ZONE button The FLEXI ZONE can be activated while the hob is on by pressing the FLEXI ZONE button once; the LEDs corresponding to both linked hotplates light up. The 2 LEDs remain lit as long as the hotplates are linked (if FLEXI ZONE button is pressed again, the hotplates are disconnected and are both set to power level 0). Pressing the +, - or Max buttons for one of the two Flexi hotplates also affects the display corresponding to the other hotplate. To deactivate the FLEXI ZONE, press the button . A timer may be set for the FLEXI zone; this appears on the display and both LEDs corresponding to the linked hotplates light up. When the Timer button is pressed, the two linked hotplates are treated as if they were a single zone. Selecting and using FLEXI ZONE To begin using the FLEXI ZONE, press the To set the power level (see above). [. . . ] Been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. If water is spilt on the surface, dry it quickly and thoroughly. Some hobs have an aluminium frame which is similar to stainless steel. [. . . ]