User manual HOTPOINT KIO 642 DD B

[. . . ] 22 Operating Instructions HOB Contents IT Italiano, 1 GB FR Français, 12 GB English, 23 Installation, 24-25 Positioning Electrical connection Description of the appliance, 26 Control panel DE Deutsch, 24 ES Espanol, 45 Start-up and use, 27-30 Switching on the hob Switching on the cooking zones Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob “Demo” mode Practical advice on using the appliance Safety devices Practical cooking advice KIO KIO KIO KIO KIO 644 DD Z 642 DD B 642 DD Z 744 DD Z 744 DO B Precautions and tips, 31 General safety Disposal Care and maintenance, 32 Switching the appliance off Cleaning the appliance Disassembling the hob Technical description of the models, 33 Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. Please keep these operating instructions for future reference. [. . . ] While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. - + or button is pressed for an extended period of time, the display scrolls quickly though the power levels and timer minutes. Set the cooking duration using the buttons. When the time has elapsed, a buzzer will sound (for one minute). The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To display the time remaining for the other programmed hotplates, press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. Control panel lock When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Switching off the hob Press the button to switch the appliance off. When the safety 0 switch has been triggered, the display shows “0”. For example: the right rear hotplate is set to 5 and will switch off after 5 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 8 hours. [. . . ] Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. If water is spilt on the surface, dry it quickly and thoroughly. Some hobs have an aluminium frame which is GB Cleaning the appliance ! [. . . ]