User manual HOTPOINT KIS 631 T Z

[. . . ] делия-Панель управления , 2 М Bа П Т Т а , 71 а а , 73 а а а , 80 , 77 , 78 5 3 13 14 1 15 9 10 6 Booster 7 12 2 4 1 8 11 GB Description of the appliance Control panel FR Description de l’appareil Tableau de bord The control panel described in this manual is only a representative example: it may not exactly match the panelon your appliance. 2 SLIDER” ZONE - switches the hotplate on/off or adjusts its power level (see Start-up and use). 3 COOKING ZONE SELECTOR indicator shows a particular cooking zone has been selected and therefore various adjustments are possible. 4 COOKING ZONE SELECTOR button is used to select the desired cooking zone. [. . . ] Press the light corresponding to the selected zone will start flashing. Set the cooking duration using the buttons. - + Switching on the hob To switch the hob on, press and hold the approximately one second. Confirm by pressing the button or automatic selection occurs after 10 seconds. The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed button hotplates, press the repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. Press the button repeatedly until the duration you wish to change is shown. Use the buttons to set the new duration. Control panel lock When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press button to lock the control panel: the indicator the light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Switching off the hob to switch off the appliance - do not Press the button rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. € Press and hold the and buttons simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. [. . . ] Some hobs have an aluminium frame which is similar to stainless steel. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. Do not use abrasive or corrosive detergents Disassembling the hob If it is necessary to disassemble the hob: 1. Loosen the screws fixing the alignment springs on each side. [. . . ]