User manual HOTPOINT KIS 644 DD Z S

[. . . ] € WARNING: The appliance and its accessible parts become hot during use. € Care should be taken to avoid touching heating elements. € Children less than 8 years of age shall be kept away unless continuously supervised. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. Booster Switching off the cooking zones To switch off the hotplate, press the ( ) button, moving the slider towards the left to return to level 0, or press the OFF button on the slider control directly. The first time the slider is pressed, a short beep will sound to acknowledge the touch. If - and only if - the power level is adjusted, another short beep will sound when the slider is released. The hotplate selection LEDs light up for the power adjustment period (10 seconds), during which the slidercan influence the selected hotplate. - + Programming the cooking duration !All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. Adjust the power level of the cooking zone. Press the light corresponding to the selected zone will start flashing. Set the cooking duration using the buttons. Set the desired duration using the buttons. Confirm by pressing the The timer begins counting down immediately. When the time has elapsed, a buzzer will sound (for one minute). Confirm by pressing the selection occurs after 10 seconds. The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed button repeatedly: the time hotplates, press the remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. [. . . ] Loosen the screws holding the fixing hooks in each corner. Take the hob out of its installation cavity. Do not attempt to repair the appliance yourself. If the appliance breaks down, contact a Service Centre. [. . . ]