User manual HOTPOINT KIX 633 C E

[. . . ] Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] The error will disappear when satisfactory ambient lighting is detected and the touch control calibration procedure will now complete satisfactorily. The activation of of the booster is signalled by a beep sound, and the letter ?P?appearing on the display corresponding to the selected cooking zone The booster works for max 10 minutes. After these 10 minutes a beep sounds and the cooking zone will return to level ?9? Starting Timer countdown. The countdown starts 10 seconds after the last operation over the INCREASE (+)/ REDUCE(-) TIME buttons. If any power is selected, a beep sounds and the timer display stops blinking. When the timer is in countdown the user can change the time at any time by touching the INCREASE / REDUCE TIME buttons. Then the countdown stops and the timer changes to time selection status waiting a time selection. When the time set on the timer has elapsed the timed heater is switched off, the timer display and the timed heater led starts blinking and a timer alarm beep sounds for one minute. The timer alarm can be cancelled by the user at any time, even during the first minute of the alarm . When the timer is in alarm status, by pressing any key of the touch control the timer is switched off. Press the few moments, the icon will stop illuminating and the lock function will be removed. All the keys on the cooking zone selection wil be locked if :the cooktop is off, , if the Control Panel Lock is activated or if an error on a cooktop occurs. Switching off the hob Press the button to switch off the appliance - do not rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. 7 GB Practical advice on using the appliance !Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Use a magnet to test the compatibility of the cookware. With no pan on the heating zone, , the heater switches off. Overheating protection If the electronic elements overheat, the number signalizing the power level starts flashing, and the letter ?c? [. . . ] After cleaning, it is advisable to rinse the surface well and dry it thoroughly. If water is spilt on the surface, dry it quickly and thoroughly. Some hobs have an aluminium frame which is similar to GB Cleaning the appliance !Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. [. . . ]