User manual HOTPOINT KTI 6114 IX

[. . . ] 2 Before using the appliance, carefully read the instructions contained in this manual, as they provide important information for ensuring safe installation, use and maintenance. 3 After the packing has been removed, make sure the appliance has not been damaged during transport. If you have any doubts, do not use the appliance. Call a qualified technician for assistance. [. . . ] Very important It is essential to instali the hob on a totally flat surtace. Any damage caused by incorrect fitting may alter the characteristics or impair performance. Insert the cooktop into the hole, pressing firmly around the frame to make it adhere to the counter top. Make certain that the seal around the outside edge of the hob is correctly installed in order to avoid any leakage into the cabinetry below. The built-in oven must be equipped with a forced air cooling system. technical specifications Electrical connection · The electrical safety of this appliance is only ensured if it is correctly earthed in compliance with electrical safety standards. The manufacturer can under on circumstances be held liable for any damages due to improper earthing. Before connecting the appliance, check that the technical characteristics indicated on the information plate correspond to the electrical installation (diameter of wires, protection devices), which must be able to accommodate the appliance’s maximum power level. Important Before any repair operation, remember to disconnect the appliance. You can connect the hob to the electrical system in two ways: · Using an electrical outlet – use a power plug that is certified for the country where the hob is being installed. Using a connection panel – if the appliance is connected permanently, it must be equipped with an all-pole circuitbreaker, in an accessible position, with a minimum gap between contacts of at least 3mm. 230V1+N connexion example (line 1 in the table) 2 4 1 Jumpe 3 Phase (brown) Neutral (blue) 5 Earth (green/yellow) In the event of an incorrect connection: - option 1: your appliance does not work, - option 2: the right cooking zones are inaccessible and the power indicators blink. ð check the position of the wires in the terminal board, ð check that all screws are tight, ð check the positioning of the jumpers. Connections KTI 5 N 4 3 2 1 L Voltage Frequency FR-AT-BE-DE-GP-ES-IE-IL-IS-IT-LU-RE-FI-GB-GR-PT-SE-MA-NZ 230V-1+N~50 Hz Fuses Diameter 20 A 25 A (KTI 6003) 2, 5 mm² 20 A 25 A (KTI 6003) 2, 5 mm² 16 A 1, 5 mm² 5 L2 5 N 4 3 2 1 L1 FR-BE-NO 230V-2~50 Hz FR-BE-CH-DE-AT-ES-IL-IT-NZ-PT-MA-LU-SE-IS-DK 400V2-N~50 Hz 4 3 2 L2 1 L1 5 L3 5 N2 5 N 4 3 2 L2 1 L1 1 L1 1 L FR-BE-NO 230V3~50 Hz NL 230V2+2-N~50 Hz CY-AU-NZ-KW 240V-1+N~50 Hz 16 A 1, 5 mm² 16 A 1, 5 mm² 20 A 25 A (KTI 6003) 2, 5 mm² 4 N1 4 3 2 L2 3 2 * Application of the simultaneity coefficient in compliance with standard EN 335-2-6 Maximum Electrical Input: KTI 6114 - 6014 KTI 6004 KTI 6003 This appliance conforms with the following European Economic Community directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications; - 93/68/EEC of 22/07/93 and subsequent modifications 6600 W 6000 W 6000 W Attention: If the cooktop is installed above a built-in oven, the electrical connection for the cooktop must be independent of that for the oven, both for safety reasons and to facilitate the removal of the oven for maintenance, repair, etc. 10 How to use the different controls When the hob is plugged in for the first time, an audio signal sounds after a few seconds. Power on To turn on th power, hold your finger on the button . How to lock the controls When the hob is on, it is possible to lock the controls so that the settings cannot be changed inavertently (due to cleaning, children playing, etc). The indicator light next to the button goes on. To modify the power level of stop cooking, all your need to do is press the button again, the indicator light goes off. You must the reselect the desired heating zone to reactivate the settings. € To stop the audio signal, remove the object causing the interruption. € To reactivate the controls, follow the procedure for turning on the hob. [. . . ] To reset the controls, press the key to switch off the hob. If you press it again, you will be able to use the hob. € • Power level 1-2 3 4 5-6 7-8 9 Maximum duration of operation 10 hours 5 hours 4 hours 3 hours 2 hours 1 hour • • • 12 Routine maintenance and cleaning Always keep the surface of the cooktop clean. However, before cleaning, make sure that the cooktop has been turned off and is no longer hot. [. . . ]