User manual HOTPOINT KZT 6104 I F IT

[. . . ] 9 Operating Instructions HOB GB Contents IT Italiano, 1 GB English, 10 FR Français, 19 Installation, 11-12 Positioning Electrical connection Description of the appliance, 13 Control panel ES Espanol, 28 PT Portuges, 37 NL Nederlands, 46 Start-up and use, 14-16 DE Deutsch, 55 Switching on the hob Switching on the cooking zones Switching off the cooking zones Programming the cooking time Control panel lock Switching off the hob Practical advice on using the appliance Safety devices KZT 6104 I F IT Precautions and tips, 17 General safety Disposal Care and maintenance, 18 Switching the appliance off Cleaning the appliance Disassembling the hob Installation  Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance.  Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Repeat the above procedure for each hotplate you wish to programme.  A few seconds after the hob is connected to the electricity supply, a buzzer will sound.  Software implementation enables the power levels to be organised in an intelligent manner, limiting the maximum electricity absorption to 3 kW. Continuous information relating to energy consumption is guaranteed by two indicator lights which are illuminated respectively when the electric absorption value is lower than 1. Switching on the hob To switch the hob on, press and hold the for approximately one second. Button Control panel lock When the hob is switched on, it is possible to lock the oven controls to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Switching on the cooking zones Each cooking zone is controlled by a device consisting of two buttons (- and +). • Press the and button to activate the hotplate, then set the power to the required level using the buttons. Switching off the hob Press the button to switch the appliance off. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. • To set the power to maximum, hold down the button briefly. Switching off the cooking zones • Press the button: the power of the cooking zone will progressively decrease until it is switched off. • Alternatively, the and buttons may be pressed simultaneously. This immediately returns the power setting to 0 and the cooking zone switches off. 14 Practical advice on using the appliance  Use cookware made from materials that are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Use a magnet to test the compatibility of the cookware. sUITABLE UNSUITABLE Safety devices Pan sensor Each cooking zone is equipped with a pan sensor device. [. . . ] The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. 17 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. [. . . ]