User manual HOTPOINT KZT 6124 ID F/HA

[. . . ] 10 Operating Instructions HOB Contents IT Italiano, 1 GB English, 11 FR Français, 21 Installation, 12-13 Positioning Electrical connection GB Description of the appliance, 14 Control panel ES Espanol, 31 Start-up and use, 15-17 KZT 6124 ID F/HA Switching on the hob Switching on the cooking zones Booster function Switching off the cooking zones Programming the cooking time Control panel lock Switching off the hob Practical advice on using the appliance Safety devices Precautions and tips, 18 General safety Disposal Care and maintenance, 19 Switching the appliance off Cleaning the appliance Disassembling the hob Technical description of the models, 20 Installation GB !Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. Please keep these operating instructions for future reference. [. . . ] Repeat the above procedure for each hotplate you wish to programme. Switching on the cooking zones Each cooking zone is controlled by a device consisting of two buttons (- and +). • Press the and button to activate the hotplate, then set the power to the required level using the buttons. • To set the power to maximum, hold down the button briefly. Booster function* The booster function for the rear cooking zones may be used to shorten heating-up times. it is activated by pressing the button. The letter “P” appears on the power indicator display. This function boosts the power of the relevant zone to 3000 W. Until the booster of one of the rear zones is activated, the front zones have a maximum power of 600 W (e. If the left rear hotplate booster is activated, the power of the left front hotplate decreases). Control panel lock When the hob is switched on, it is possible to lock the oven controls to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Switching off the hob Press the button to switch the appliance off. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. 15 GB Practical advice on using the appliance  Use cookware made from materials that are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Use a magnet to test the compatibility of the cookware. sUITABLE UNSUITABLE Safety devices Pan sensor Each cooking zone is equipped with a pan sensor device. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. [. . . ] If water is spilt on the surface, dry it quickly and thoroughly. Some hobs have an aluminium frame which is GB Cleaning the appliance  Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. Never use steam cleaners or pressure cleaners on the appliance. [. . . ]