User manual HOTPOINT LD 20

[. . . ] LD 20 GB Dishwasher Instructions for installation and use This manual explains pleasantly all your new electric household appliance has to offer. In addition, you will discover a world of useful hints and handy tips to help you get a better wash from your dishwasher and to make it last longer. Quick guide to your dishwasher 1. 8) Installation, after delivery or your moving house, is the most important procedure for the correct operation of your dishwasher. That the electricity system is in accordance with norms; 2. [. . . ] You should fill it up when the low rinse aid indicator light "O" lights up on and the words "add rinse aid" scroll across the display. Loading the rinse aid. To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: use a screwdriver or a coin to adjust the dosage adjuster F situated underneath the lid C. F C You can choose from six different positions. It is normally set to 4. Water in your home Loading the salt. Always use salt which is intended for dishwasher use. The salt container is situated underneath the lower rack, fill it up as follows: 1. Pull out the lower rack completely, unscrew and remove the container cap 2. First fill the container up with water (you won't have to do this again next time) 3. Put the dishwasher funnel on the hole and pour in approximately two kilos of salt. It is normal that some water comes out of the container. The salt container should be filled up when the low salt indicator light "M" lights up and the words "add salt" scroll across the display. Never without salt Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. Water hardness varies according to where you live. If the water in your home is hard, without water softening, incrustations would form on your dishes. Your dishwasher is fitted with a water softener which uses special salt to get rid of limescale in the water. Intelligent salt. Your dishwasher can adjust its salt consumption according to the hardness of the water in your home. It will add the correct quantity to the wash cycle, thus optimising and customising the salt consumption (not too much nor too little). At the end of the wash cycle, if your dishwasher detects a water hardness which is below the default threshold, the message "do not use any salt" will appear. To prevent rust from forming, load the salt just before beginning a wash cycle. 6 ARISTON DISHWASHER - Instructions for installation and use Language setting and demo programme Access to the menu Keep these two buttons pressed together for approximately 3 seconds to enter the menu. The button works as the "Mode" button: to allow you to scroll along the menu options. The button works as the "Select" button: to allow you to select the selection shown by the display. The button works as the "Canc" button: to allow you to go back to the last menu level; press it repeatedly to quit the menu and go back to normal mode. [. . . ] This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. Use a cloth dampened with lukewarm soapy water only. [. . . ]