User manual HOTPOINT LFD 11M121 B EU

[. . . ] Please read these instructions carefully: they contain important information on installation, use and safety. This appliance is designed for domestic use or similar applications, for example: - staff kitchen areas in shops, offices and other work environments; - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. € Keep detergent and rinse aid out of reach of children. € The packaging material should not be used as a toy for children. [. . . ] Using excessive detergent may result in foam residue remaining in the machine after the cycle has ended. The use of tablets is only recommended for models which offer the MULTI-FUNCTIONAL TABLETS option. To achieve the best results from each washing and drying cycle, powder detergent, liquid rinse aid and salt should be used. Adding extra crockery Press the Start/Pause button: the display shows PAUSE. Open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the Start/Pause button: the cycle starts from the point at which it was interrupted. If the delayed start has been set, at the end of the countdown the wash cycle will not start. Press the Start/Pause symbol to pause the machine; the wash cycle is stopped. At this stage it is not possible to change the wash cycle. Accidental interruptions If the door is opened during the wash cycle, the text CLOSE THE DOOR appears on the display. If there is a power cut, the cycle stops. com This option optimises washing and drying results. When using multi-functional tablets, press the MULTIFUNCTIONAL TABLETS button; the corresponding symbol will light up. If the button is pressed again, the option will be deselected. The “Multi-functional tablets” option results in a longer wash cycle. The use of tablets is only recommended for models having this option and it is not recommended with wash cycles which do not specify the use of multi-functional tablets. Multi-functional tablets* (Tabs) EN Wash options* The OPTIONS may only be set, changed or reset after the wash cycle has been selected and before the Start/ Pause button has been pressed. Only the options which are compatible with the type of wash cycle set may be selected. If an option is not compatible with the selected wash cycle (see Table of wash cycles), the corresponding symbol flashes rapidly 3 times. If an option is selected which is not compatible with another (previously selected) option, it will flash 3 times and switch off, while the most recently selected option will remain active. To deselect an option which has been set by mistake, press the corresponding button again. Zone Wash This option makes it possible to carry out the wash cycle in the selected rack only. [. . . ] € An excessive amount of foam has been produced: the detergent has not been measured out correctly or it is not suitable for use in dishwashers (see Start-up and use. ) The dishes and glasses are covered • The level of refined salt is low or the dosage setting is not suitable for the hardness of the water (see Rinse aid and salt. ) in a white film or limescale deposits. € The lid on the salt dispenser is not closed properly. [. . . ]