User manual HOTPOINT LSTA 5397 X

[. . . ] Operating instructions DISHWASHER EN English, 1 PL Polski, 15 Contents Product Fiche, 2 Precautions, advice and Assistance, 3-4 General safety Disposal Saving energy and respecting the environment Assistance EN Installation, 5-6 Positioning and levelling Connecting the water and electricity supplies Advice regarding the first wash cycle Technical data Ecodesign Regulation Description of the appliance, 7 Overall view Control panel LSTA+ 5397 Loading the racks, 8 Lower rack Cutlery basket Upper rack Start-up and use, 9 Starting the dishwasher Measuring out the detergent Wash cycles, 10 Table of wash cycles Wash options, 11 Rinse aid and refined salt, 12 Measuring out the rinse aid Measuring out the refined salt Care and maintenance, 13 Shutting off the water and electricity supplies Cleaning the dishwasher Preventing unpleasant odours Cleaning the sprayer arms Cleaning the water inlet filter Cleaning the filters Leaving the machine unused for extended periods Troubleshooting, 14 1 Product Fiche EN Product Fiche Brand Model Rated capacity in standard place settings (1) Energy efficiency class on a scale from A+++ (low consumption) to D (high consumption) Energy consumption per year in kWh (2) Energy consumption of the standard cleaning cycle in kWh Power consumption of the off-mode in W Power consumption of the left-on mode in W Water consumption per year in litres (3) Drying efficacy class on a scale from G (low efficacy) to A (high efficacy) Programme time for standard cleaning cycle in minutes The duration of the left-on mode in minutes Noise in dB(A) Re 1pW Built-in model HOTPOINT/ARISTON LSTA+ 5397 X 10 A+ 237. 0 A 170’ 10 44 Yes NOTES 1) The information on the label and fiche relates to the standard cleaning cycle, this programme is suitable to clean normally soiled tableware and it is the most efficient programme in terms of combined energy and water consumption. The standard cleaning cycle corresponds to the Eco cycle. 2) Based on 280 standard cleaning cycles using cold water fill and the consumption of the low power modes. [. . . ] If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Modifying a wash cycle in progress If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has only just begun: open the door, avoiding the escaping steam, and press and hold the ON/OFF button; the machine will switch off with a long beep. Switch the machine back on using the ON/OFF button and select the new wash cycle and any options desired; start the cycle by closing the door. Adding extra crockery Without switching off the machine, open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Close the door: the cycle starts from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or once the electricity supply is restored. 9 Wash cycles EN For available OPTIONS please refer to the Table of options on the Start-up and use page. The number and type of wash cycles and options may vary depending on the dishwasher model. Wash cycle selection instructions Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. Pre-wash for dishes while awaiting completion of the load with the dishes from the next meal. heavily soiled dishes and pans (not to be used for delicate items). Economic and fast wash to be used for lightly soiled dishes. (Run cycle immediately after use) (2 plates + 2 glasses + 4 pieces of cutlery + 1 saucepan + 1 small frying pan). Economic and fast wash for delicate items which are sensitive to high temperatures. (Run cycle immediately after use) (glasses upper rack + delicate plates lower rack). Quick wash and dry cycle, suitable for crockery and pans with a normal soil level. It is ideal for night-time operation of the appliance. Wash cycle Powder 25 g (A) Detergent (A) = compartment A (B) = compartment B Liquid 25 ml (A) Tablets 1 (A) Wash cycles which include drying Yes Options Wash cycle duration (tolerance ±10%) Hrs. Short Time 25 g (A) 4 g (B) 25 ml (A) 1 (A) Yes A– B–C 1:30’ 21 ml (A) 4 ml (B) 1 (A) 1 (A) 1 (bottom of the appliance) 1 (A) Yes A-C 1:20’ 8. ultra Intensive 25 ml (A) 4 ml (B) Yes A–B-C 2:35’ 21 g (A) 4 g (B) 9. Good Night 21 ml (A) 4 ml (B) Yes A-C 3:30’ Notes: Optimum performance levels when using the “”Rapid wash” cycle can be achieved by observing the maximum amounts of crockery specified. [. . . ] € The rinse aid has been used up or the dosage is too low. • The rinse aid dosage is too high. € • • • • • • • • A wash cycle without a drying program has been selected. The rinse aid has been used up or the dosage is too low (see Rinse aid and salt). [. . . ]