User manual HOTPOINT LSTB 4B00 RU

[. . . ] Read the instructions carefully, as they include important information on safe installation, use and maintenance. This appliance was designed for domestic use or similar applications, for example: - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. Remove the appliance from all packaging and make sure it was not damaged during transportation. If it was damaged, contact the retailer and do not proceed any further with the installation process. [. . . ] € It is important that the salt dispenser be never empty. • It is important to set the water hardness. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • When the LOW RINSE AID indicator light in the control panel is lit *; • When the green float* on the cap of the salt dispenser is no longer visible. Remove the lower rack and unscrew the container cap (anticlockwise). Only the first time you do this: fill the water dispenser up to the edge. Position the funnel (see figure) and fill the salt container right up to its edge (approximately 1 kg); it is not unusual for a little water to leak out. Remove the funnel and wipe any salt residue away from the opening; rinse the cap under running water and then screw it on. It is advisable to perform this procedure every time you add salt to the container. No preventive rinsing is needed under running water. Arrange the crockery so that it is held in place firmly and does not tip over; and arrange the containers with the openings facing downwards and the concave/convex parts placed obliquely, thus allowing the water to reach every surface and flow freely. Make sure that the lids, handles, trays and frying pans do not prevent the spray arms from rotating. NEVER raise or lower the rack on one side only. Some dishwasher models are fitted with a sliding tray which can be used to hold small crockery and cutlery. For optimum washing performance, avoid positioning bulky crockery directly below the tray. ) If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the lower position, press the levers (A) at the sides of the rack and follow the rack down. € Parts in synthetic material which do not withstand high temperatures. The colours of glass decorations and aluminium/silver pieces can change and fade during the washing process. Crystal objects) can become opaque after a number of wash cycles too. Tips: • Only use glasses and porcelain guaranteed by the manufacturer as dishwasher safe. • Use a delicate detergent suitable for crockery. € Collect glasses and cutlery from the dishwasher as soon as the wash cycle is over. [. . . ] Strongly push the door until a “clacking” noise is heard. € The dishes are rattling against each other or against the sprayer arms. Place the dishes properly and make sure the sprayer arms can rotate freely. € Too much foam: the detergent has not been measured out correctly or it is not suitable for use in dishwashers. [. . . ]