User manual HOTPOINT LTF 11M121 EU

[. . . ] ақша, 31 Contents Product Fiche, 2 Precautions, advice and Assistance, 3-4 General safety Disposal Saving energy and respecting the environment Assistance EN Installation, 5-6 Positioning and levelling Connecting the water and electricity supplies Advice regarding the first wash cycle Technical data Description of the appliance, 7 LTF 11M121 Overall view Control panel Loading the racks, 8-9 Lower rack Cutlery basket Upper rack Cutlery tray Adjusting upper rack Start-up and use, 10 Starting the dishwasher Measuring out the detergent Wash cycles, 11 Table of wash cycles Special wash cycles and Options, 12 Rinse aid and refined salt, 13 Measuring out the rinse aid Measuring out the refined salt Care and maintenance, 14 Shutting off the water and electricity supplies Cleaning the dishwasher Preventing unpleasant odours Cleaning the sprayer arms Cleaning the water inlet filter Cleaning the filters Leaving the machine unused for extended periods Troubleshooting, 15 1 Product Fiche EN Product Fiche Brand Model Rated capacity in standard place settings (1) Energy efficiency class on a scale from A+++ (low consumption) to D (high consumption) Energy consumption per year in kWh (2) Energy consumption of the standard cleaning cycle in kWh Power consumption of the off-mode in W Power consumption of the left-on mode in W Water consumption per year in litres (3) Drying efficacy class on a scale from G (low efficacy) to A (high efficacy) Programme time for standard cleaning cycle in minutes The duration of the left-on mode in minutes Noise in dB(A) Re 1pW Built-in model HOTPOINT ARISTON LTF 11M121 14 A++ 265. 0 A 190’ 10 41 Yes NOTES 1) The information on the label and fiche relates to the standard cleaning cycle, this programme is suitable to clean normally soiled tableware and it is the most efficient programme in terms of combined energy and water consumption. The standard cleaning cycle corresponds to the Eco cycle. 2) Based on 280 standard cleaning cycles using cold water fill and the consumption of the low power modes. [. . . ] Close the lid of the detergent dispenser by pulling it up until the closing device is secured in place. The detergent dispenser automatically opens up at the right time according to the wash cycle. If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved. Only use detergent which has been specifically designed for dishwashers. Using excessive detergent may result in foam residue remaining in the machine after the cycle has ended. The use of tablets is only recommended for models which offer the MULTI-FUNCTIONAL TABLETS option. To achieve the best results from each washing and drying cycle, powder detergent, liquid rinse aid and salt should be used. Modifying a wash cycle in progress If a mistake was made during the wash cycle selection process, it is possible to change the cycle, provided that it has only just begun: open the door taking care to avoid the escaping steam, by pressing and holding the ON/OFF button, the machine will switch off. Switch the machine back on using the ON/OFF button and select the new wash cycle and any options desired; start the cycle by closing the door. Adding extra crockery Without switching off the machine, open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Shut the door and the cycle will begin from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Based on the different conditions of use, the wash-cycle duration and data can change. The number and type of wash cycles and options may vary depending on the dishwasher model. Wash cycle which include drying Yes Yes Yes No Yes Yes No Yes No Yes No Approximate duration of wash cycles 03:10’ 02:00’ - 03:10’ 01:30’ - 02:30’ 00:40’ - 01:20’ 02:00’ 01:40’ 00:30’ 03:30’ 00:12’ 01:20’ 00:50’ Water consumption (l/cycle) 9, 0 14, 0 - 15, 5 14, 5 – 16, 0 13, 0 - 14, 5 18, 0 11, 0 9, 0 15, 0 4, 5 10, 0 8, 0 Energy consumption (KWh/cycle) 0, 93 1, 40 - 1, 70 1, 15 - 1, 30 1, 15- 1, 25 1, 25 1, 05 0, 50 1, 15 0, 01 1, 15 0, 80 EN Wash cycle 1. Self Clean Options Delayed start – Tabs – Extra Dry Delayed start – Tabs – Extra Dry – Zone wash – Short Time Delayed start – Tabs – Extra Dry – Zone wash – Short Time Delayed start – Tabs Delayed start – Tabs – Extra Dry – Short Time Delayed start – Tabs – Extra Dry Delayed start – Tabs Delayed start – Tabs – Extra Dry Delayed start Delayed start Delayed start Instructions on wash-cycle selection and detergent dosage 1. The ECO wash cycle is the standard cycle to which the energy label data refers. It can be used to wash crockery with a normal soil level and is the most efficient cycle in terms of energy and water consumption for this type of crockery. Wash spread over the two racks: delicate on upper rack and heavy-duty for pans on lower rack. Cycle for delicate items, which are more sensitive to high temperatures 35 gr/ml – 1 Tab 7. Fast cycle to be used for slightly dirty dishes (ideal for 2 place settings) 25 gr/ml – 1 Tab 8. [. . . ] Strongly push the door until a “clacking” noise is heard. € The dishes are rattling against each other or against the sprayer arms. €  xcessive foam presence: the detergent has not been measured out correctly or it is not E suitable for use in dishwashers. €  he level of the refined salt is low or the dosage setting is not suited to the hardness of the T water (see Rinse aid and salt). [. . . ]