User manual HOTPOINT MTP 1912 F/HA

[. . . ] 00 04/2007 I 12 Operating Instructions 2-DOOR FRIDGE Contents I Italiano, 1 GB GB English, 13 F Français, 25 Installation, 14 Positioning and connection Reversible doors Description of the appliance, 15-16 Control panel Overall view D Deutsch, 37 NL Nerderlands, 49 Accessories, 17 Refrigerator compartment Freezer compartment Start-up and use, 18-19 MTP 1912 F/HA Starting the appliance Using the display Chiller system Using the refrigerator to its full potential Using the freezer to its full potential Maintenance and care, 20 Switching the appliance off Cleaning the appliance Avoiding mould and unpleasant odours Replacing the light bulb Precautions and tips, 21 General safety Disposal Respecting and conserving the environment Troubleshooting, 22 Assistance, 23 13 Installation GB !Before operating your new appliance please read these instructions carefully. They contain important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] More specifically, each time one of the buttons is pressed the temperature is increased or decreased by 1°, and the level of cold is adjusted accordingly. The temperature values that may be selected for the refrigerator compartment are +12°C, +7°C, +6°C, +5°C, +4°C, +3°C and +2°C, while the values that may be set for the freezer are -18°C, -19°C, -120°C, -21°C, -22°C, -24°C and -26°C. 18 Chiller system No Frost The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. The system maintains an optimal humidity level in the compartment, preserving the original quality of the food, preventing the food from sticking together and making defrosting a thing of the past. Do not block the aeration cells by placing food or containers in direct contact with the refrigerating back panel. Using the freezer to its full potential • Adjust the temperature using the display. • To freeze (if the freezer is already operating): - for small quantities which are less than those indicated on the data plate, press the rapid freezing SUPER FREEZE button (corresponding indicator light illuminates), insert the food and close the door. The function is disabled automatically after 24 hours or when optimal temperatures have been reached (indicator light goes out); - for large quantities which are greater than the maximum load indicated on the data plate, hold down the rapid freezing SUPER FREEZE button until the corresponding indicator light begins to flash. Hold the ON/OFF button down for more than two seconds until OFF appears on both indicator displays (refrigerator and freezer). If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. To restore normal operation, hold the ON/OFF button down for more than two seconds. To disconnect the appliance, follow points 1 and 2 above. Replacing the light bulb To replace the light bulb in the refrigerator compartment, disconnect the plug from the electricity mains. Access the light bulb as shown (see diagram) and replace it with a similar light bulb, the power of which should not exceed 10 W. Cleaning the appliance • The external and internal parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. • The back of the appliance may collect dust. This can be removed by carefully using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug disconnected from the electricity mains before it is cleaned. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic, odour free materials. Food should be wrapped well and containers closed properly in order to maintain this hygiene. This will also prevent the formation of stains. [. . . ] Press a second time to display the set value on the freezer status bar, switch off the ALARM LED and restore normal operation. • • • • The doors do not close properly or the seals are damaged. The temperature that has been set is too high (see Start-up and use). The refrigerator or the freezer have been over-filled. [. . . ]