User manual HOTPOINT NIO 844 DO B AUS

[. . . ] Operating Instructions HOB GB GB English, 1 Contents Installation, 2-3 Positioning Electrical connection Description of the appliance, 4 Control panel Start-up and use, 5-8 Switching on the hob Switching on the cooking zones Medium function Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob “Demo” mode Practical advice on using the appliance Safety devices Practical cooking advice NIO 844 DO B AUS Precautions and tips, 9 General safety Disposal Care and maintenance, 10 Switching the appliance off Cleaning the appliance Disassembling the hob Technical description of the models, 11 Service information, 12 Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. Please keep these operating instructions for future reference. [. . . ] if the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. Programming the cooking duration !All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. Adjust the power level of the cooking zone. In order to switch the hob on again, you must first remove the lock function. “Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. • Press and hold the you wish to change is shown. 3. Confirm by pressing the To cancel a programme, follow the above instructions. At step 2, press the - button: the + and buttons duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode. simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. Release the press the button; Timer The hob must be switched on. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer . + and buttons and • The display will show the text DE and MO and the hob will be switched off. • When the hob is switched on again it will be set to the “demo” mode. To exit this mode, follow the procedure described above. The display will show the text DE and OF and the hob will be switched off. When it is next switched on, the hob will function normally. indicator light is illuminated 2. Set the desired duration using the buttons. - + and 6 will be switched off. When it is next switched on, the hob will function normally. • A pan whose diameter is too small • The pan has been removed from the hotplate. Overheating protection If the electronic elements overheat, the hob switches off automatically and flashing number. [. . . ] Some hobs have an aluminium frame which is Cleaning the appliance !Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. !Never use steam cleaners or pressure cleaners on similar to stainless steel. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. the appliance. [. . . ]