User manual HOTPOINT NRA 640 C AUS

[. . . ] Operating Instructions HOB Contents Installation, 2-4 Positioning Electrical connection GB GB English, 1 Description of the appliance, 5 Control panel Start-up and use, 6-9 Switching on the hob Switching on the cooking zones Switching off the cooking zones Heating elements Control panel lock Switching off the hob Practical advice on using the appliance Safety devices Practical cooking advice NRA 640 C AUS Precautions and tips, 10 General safety Disposal Care and maintenance, 11 Switching the appliance off Cleaning the appliance Disassembling the hob Technical description of the models, 12 Service information, 12 Installation !Before operating your new appliance please read GB this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. Please keep these operating instructions for future reference. [. . . ] The indicator light corresponding to the selected zone will start flashing. Set the cooking duration using the buttons. Confirm by pressing the button or automatic selection occurs after 10 seconds. The timer begins counting down immediately. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Repeat the above procedure for each hotplate you wish to programme. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. • Press and hold the you wish to change is shown. 3. Confirm by pressing the To cancel a programme, follow the above instructions. At step 2, press the - button: the + and buttons duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode. simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. Release the press the button; + and buttons and Timer The hob must be switched on. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer . • The display will show the text DE and MO and the hob will be switched off. • When the hob is switched on again it will be set to the “demo” mode. To exit this mode, follow the procedure described above. The display will show the text DE and OF and the hob will be switched off. When it is next switched on, the hob will function normally. indicator light is illuminated 2. Set the desired duration using the buttons. Confirm by pressing the - + and Practical advice on using the appliance button. To obtain the best results from your hob: • Use pans with a thick, flat base in order to fully utilise the cooking zone. The timer begins counting down immediately. [. . . ] Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can achieve excellent results by using a rust-proof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water. • If any plastic or sugary substances are accidentally melted on the hob, remove them immediately with the scraper, while the surface is still hot. • Once it is clean, the hob may be treated with a special protective maintenance product: the invisible film left by this product protects the surface from drips during cooking. [. . . ]