User manual HOTPOINT PA 200I EBK0

[. . . ] Keep warm mode Simmer mode Timer Fry mode Boil mode Boost mode On/Standby Power regulating control + Power regulating control Child lock INTRODUCTION Thank you for purchasing our product. In doing so, you have opted for an effective, high performing appliance. If the instructions for correct use of this appliance are not observed, the manufacturer’s liability for any resulting damage will be excluded. Operating instructions may describe different models. [. . . ] When using the appliance you can hear a noise due to high frequency electromagnetic wave. Shape requirement: you can use pots with a diameter (on the higher part) from 14. 5 to 18 cm Safety pack • • • • • Over-temperature protection. If the temperature inside the induction cooker body is too high, the appliance will stop heating. over current or voltage abnormality protection. When voltage is abnormal or current changes abruptly, the induction cooker will stop. Once the issues are solved, the induction cooker will work again normally. If a pot is moved during process, the unit will stop heating immediately. The appliance will emit a sound and after 1 minute it will automatically return to standby mode. When the time selected is reached, the induction cooker will shut off automatically until the user triggers the timer again. This pad allows locking all the control panel to simplify the cleaning but also to preserve children from all risks. USING YOUR APPLIANCE Use the control panel • • The sensitive pads work with a sense of touch. Use the base of your finger and not the tip Starting your appliance • Suitable and unsuitable pots and containers It’s necessary to use suitable pots and containers. Pan test with a magnet: if the magnet “sticks” to the base of the pan, then it is suitable for use with induction cooking. requirement for pot materials: containing magnetic induction materials. All the test and authentication of thus product is based on the stainless steel 430 cookware (bottom diameter 180+/- 10mm). The other cookware can not guarantee the best results and performance. After the power supply is connected, the buzzer sounds and the screen show “L” blinking, indicating that the hotplate is in a state of standby. So that the appliance is ready to be programmed, press on On/standby (13). After pressing this button, the induction cooker can be set. Never put an empty container on the ceramic plate before switching on the appliance. Under the standby mode, if no function button is pressed for about 10 seconds, the induction cooker will switch off automatically. [. . . ] The default power level shall be level 10. After about 7 minutes, it will turn to 8 level power. In this mode, the default working time is 15 minutes. It is recommended to put water that occupies 30% to 80% of the pot capacity when boiling water. [. . . ]