User manual HOTPOINT PC 604 X

[. . . ] The appliance is not intended to be operated by means of an external timer or separate remote control system. Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. If the appliance is to be installed above a built-in electric oven, the electrical connection of the hob and the oven must be carried out separately, both for electrical safety purposes and to make extracting the oven easier. Electrical connection The electric hobs are supplied without power supply cable since the cable must be sized according to the type of electrical connection used (see attached connection diagram). Follow these steps to connect the cable: • Open the terminal box by removing the screws "V" and opening the cover (see figure). € Connect the wires as shown in the diagram. € Fix the cable using the cable clamp "F", replace the cover and fasten it using the screws "V" (see figure). V 1 2 3 4 5 F 4 Description of the appliance Overall view GB ELECTRIC PLATE Control knobs for the cook-top ELECTRIC PLATE Pilot lamp of the ELECTRIC PLATE • The ELECTRIC PLATE vary in diameter and power: "normal" and "fast". The latter can be identified by a red boss in the center of the hot plate itself. The position of the corresponding electric hot plate is indicated on each control knob. € The ELECTRIC PLATE ON indicator light switches on whenever the knob is moved from the 'off' position. • The ELECTRIC PLATE control knob is a device used to regulate power. The knob may be turned clockwise or anticlockwise and set to six different positions: Setting Normal or Fast Plate 0 1 2-5 6 Off Low Medium High !Please refer to the "Practical advice on using the appliance" section for a list of the relative positions and their recommended uses. This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. Responsibility for their safety or receive preliminary instructions relating to the operation of the appliance. € Do not let children play with the appliance. € The appliance is not intended to be operated by means of an external timer or separate remote-control system. GB General safety • This manual is for a class 3 built-in cooktop. € These instructions are only valid for the countries the symbols for which appear on the manual and the serial plate. € This appliance is designed for non-professional use in the home. [. . . ] Never use the services of an unauthorised technician. Please have the following information to hand: • The type of problem encountered. This information can be found on the data plate located on the appliance and/or on the packaging. Do not use abrasive or corrosive detergents, stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface. [. . . ]