User manual HOTPOINT PC 640 T GH

[. . . ] ‬‬ ‫65，‪维护与保养‬‬ ‫65，‪故障排除‬‬ ‫تعليمات التشغيل‬ ‫المحتويات‬ ‫رف تسخين‬ ‫تعليمات التشغيل،2‬ ‫تحذيرات،3‬ ‫المساعدة،5‬ ‫وصف الجهاز،8‬ ‫التركيب، 36‬ ‫بدء التشغيل واالستخدام،95‬ ‫وسائل الحذر والنصائح، 85‬ ‫استكشاف المشاكل وحلها، 75‬ ‫الصيانة والعناية، 75‬ Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Sticker are available from any of our Service Centres. replacing the nozzles on separate “double flame “ burners 1. Remove the grids and slide the burners from their housings. The burner consists of 2 separate parts (see figure); 2. Unscrew the burers with a 7 mm wrench spanner. The internal burner has a nozzle, the external burner has two (of the same size). Replace the nozzle with models suited to the new type of gas (see table 1). Replace all the components by repeating the steps in reverse order. replacing the Triple ring burner nozzles 1. Remove the pan supports and lift the burners out of their housing. The burner consists of two separate parts (see pictures). Unscrew the nozzles using a 7 mm socket spanner. Replace the nozzles with models that are configured for use with the new type of gas (see Table 1). The two nozzles have the same hole diameter. Replace all the components by completing the above operations in reverse order. € Adjusting the burners’ primary air Does not require adjusting. • Setting the burners to minimum 1. Turn the tap to the low flame position; 2. Emove the knob and adjust R the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. Some appliances have a safety device (thermocouple) fitted. [. . . ] Check whether: • The gas holes on the burner are clogged. € All the movable parts that make up the burner are mounted correctly. € There are draughts near the appliance. The flame dies in models with a safety device. [. . . ]