User manual HOTPOINT PCN 642 IX/HA

[. . . ] PCN 642 IX/HA Français Mode d’emploi TABLE DE CUISSON Sommaire Mode d’emploi, 1 Avertissements, 4 Assistance, 6 Description de l’appareil, 8 Installation, 22 Mise en marche et utilisation, 26 Précautions et conseils, 26 Nettoyage et entretien, 27 Anomalies et remèdes, 27 Italiano Español Istruzioni per l’uso PIANO Sommario Istruzioni per l’uso, 1 Avvertenze, 3 Assistenza, 6 Descrizione dell’apparecchio, 8 Installazione, 10 Avvio e utilizzo, 14 Precauzioni e consigli, 14 Manutenzione e cura, 15 Anomalie e rimedi, 15 Manual de instrucciones ENCIMERA Sumario Manual de instrucciones, 1 Advertencias, 4 Asistencia, 6 Descripción del aparato, 8 Instalación, 28 Puesta en funcionamiento y uso, 32 Precauciones y consejos, 32 Mantenimiento y cuidados, 33 Anomalías y soluciones, 33 English Portuges Operating Instructions HOB Contents Operating Instructions, 1 Warnings, 3 Assistance, 6 Description of the appliance, 8 Installation, 16 Start-up and use, 20 Precautions and tips, 20 Maintenance and care, 21 Troubleshooting, 21 Instruções para a utilização PLANO Índice Instruções para a utilização, 1 Advertências, 5 Assistência, 7 Descrição do aparelho, 9 Instalação, 34 Início e utilização, 38 Precauções e conselhos, 38 Manutenção e cuidados, 39 Anomalias e soluções, 39 ‫تعليمات التشغيل‬ ‫المحتويات‬ ‫رف تسخين‬ ‫تعليمات التشغيل،2‬ ‫تحذيرات،5‬ ‫المساعدة،7‬ ‫وصف الجهاز،9‬ ‫التركيب، 14‬ ‫بدء التشغيل واالستخدام،24‬ ‫وسائل الحذر والنصائح، 24‬ ‫الصيانة والعناية، 24‬ ‫استكشاف المشاكل وحلها، 44‬ Avvertenze ATTENZIONE: Questo apparecchio e le sue parti accessibili diventano molto caldi durante l’uso. Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. [. . . ] Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. Checking the tightness of the connection !When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Remove the hob grids and slide the burners off their seats. Unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 “Burner and nozzle characteristics”). Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Sticker are available from any of our Service Centres. € Adjusting the burners’ primary air Does not require adjusting. Electrical connection Hobs equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate (this is located on the lower part of the appliance). The earth wire in the cable has a green and yellow cover. If the appliance is to be installed above a built-in electric oven, the electrical connection of the hob and the oven must be carried out separately, both for electrical safety purposes and to make extracting the oven easier. Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • the appliance is earthed and the plug is compliant with the law. When using models with an gas burner ignition, to light the selected burner press down and turn the corresponding knob anticlockwise to maximum position, keeping it pressed until the burner has ignitied. If a flame is accidentally extinguished, turn off the control knob and wait for at least 1 minute before trying to relight it. [. . . ] € The pan support grids have been positioned correctly. GB Respecting and conserving the environment • Cook your food in closed pots or pans with well-fitting lids and use as little water as possible. Cooking with the lid off will greatly increase energy consumption. € If you are cooking something that takes a long time, it’s worth using a pressure cooker, which is twice as fast and saves a third of the energy. [. . . ]