User manual HOTPOINT PCN 732 T/D2/IX/A

[. . . ] PCN 642 T/IX/A PNC 722 T/D2/IX/A PCN 732 T/D2/IX/A Portuges Instruções para a utilização PLANO Índice Instruções para a utilização, 1 Advertências, 3 Assistência, 5 Descrição do aparelho, 6 Instalação, 22 Início e utilização, 26 Precauções e conselhos, 26 Manutenção e cuidados, 27 Anomalias e soluções, 28 English 中文 Operating Instructions HOB Contents Operating Instructions, 1 Warnings, 2 Assistance, 5 Description of the appliance, 6 Installation, 8 Start-up and use, 12 Precautions and tips, 12 Maintenance and care, 13 Troubleshooting, 13 操作说明 HOB 目录 操作说明，1 警告，3 帮助，5 器具 说明，6 安装，29 启动和使用，33 注意事项和技 ，33 维护与保养，34 故障排除，34 Français Mode d’emploi TABLE DE CUISSON Sommaire Mode d’emploi, 1 Avertissements, 2 Assistance, 5 Description de l’appareil, 6 Installation, 15 Mise en marche et utilisation, 19 Précautions et conseils, 19 Nettoyage et entretien, 20 Anomalies et remèdes, 21 ‫تعليمات التشغيل‬ ‫المحتويات‬ ‫رف تسخين‬ 1،‫تعليمات التشغيل‬ 3،‫تحذيرات‬ 5،‫المساعدة‬ 7،‫وصف الجهاز‬ 35 ،‫التركيب‬ 38،‫بدء التشغيل واالستخدام‬ 38 ،‫وسائل الحذر والنصائح‬ 40 ،‫الصيانة والعناية‬ 40 ،‫استكشاف المشاكل وحلها‬ Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] The burner consists of 2 separate parts (see figure); 2. Unscrew the burers with a 7 mm wrench spanner. The internal burner has a nozzle, the external burner has two (of the same size). Replace the nozzle with models suited to the new type of gas (see table 1). Electrical connection Hobs equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate (this is located on the lower part of the appliance). The earth wire in the cable has a green and yellow cover. If the appliance is to be installed above a built-in electric oven, the electrical connection of the hob and the oven must be carried out separately, both for electrical safety purposes and to make extracting the oven easier. Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • the appliance is earthed and the plug is compliant with the law. € the socket can withstand the maximum power of the appliance, which is indicated on the data plate. The position of the corresponding gas burner is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: ● Off Maximum Minimum To light one of the burners, hold a lit match or lighter near the burner and, at the same time, press down and turn the corresponding knob anti-clockwise to the maximum setting. Since the burner is fitted with a safety device, the knob should be pressed for approximately 2-3 seconds to allow the automatic device keeping the flame alight to heat up. When using models with an ignition button, light the desired burner pressing down the corresponding knob as far as possible and turning it anticlockwise towards the maximum setting. If a flame is accidentally extinguished, turn off the control knob and wait for at least 1 minute before trying to relight it. To switch off the burner, turn the knob in a clockwise direction until it stops (when reaches the “●” position). The “separate double flame” burner* This burner consists of two concentric burners which can operate either together or separately. Use of the double flame on the maximum setting gives a very high power which reduces cooking times with respect to conventional burners. [. . . ] If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. Respecting and conserving the environment • Cook your food in closed pots or pans with well-fitting lids and use as little water as possible. Cooking with the lid off will greatly increase energy consumption. [. . . ]