User manual HOTPOINT PF 604

[. . . ] • Hoods must be installed according to their relative installation instruction manuals and at a minimum distance of 650 mm from the hob. • Place the wall cabinets adjacent to the hood at a minimum height of 420 mm from the hob (see figure). • If the hob is installed beneath a wall cabinet, the latter must be situated at a minimum of 700 mm above the hob (see figure). [. . . ] • Fix the cable using the cable clamp "F", replace the cover and fasten it using the screws "V" (see figure). V 1 2 3 4 5 F  The cable must be checked regularly and replaced by authorised technicians only (see Assistance).  The manufacturer declines any liability should these safety measures not be observed.  If the appliance is to be installed above a built-in electric oven, the electrical connection of the hob and the oven must be carried out separately, both for electrical safety purposes and to make extracting the oven easier. 5 CEI-UNEL 35363 1 R 2 S 3 T 4 4 4 R 5 N 1 1 2 R 3 S N 5 5 N 2 3 10 Description of the appliance Overall view GB ELECTRIC PLATE Control knobs for the cook-top ELECTRIC PLATE Pilot lamp of the ELECTRIC PLATE • The ELECTRIC PLATE vary in diameter and power: "normal" and "fast". The latter can be identified by a red boss in the center of the hot plate itself.  The position of the corresponding electric hot plate is indicated on each control knob. • The ELECTRIC PLATE ON indicator light switches on whenever the knob is moved from the 'off' position. The ELECTRIC PLATE control knob is a device used to regulate power. The knob may be turned clockwise or anticlockwise and set to six different positions: Setting Normal or Fast Plate 0 1 Off Low 2 - 5 Medium 6 High  Please refer to the "Practical advice on using the appliance" section for a list of the relative positions and their recommended uses. 11 Precautions and tips G B  This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. • The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. General safety • This manual is for a class 3 built-in cooktop. [. . . ] 12 Maintenance and care Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. technical characteristic DATA PLATE Collegamenti elettrici tensione 220-230V/380-400V~ 3N 50/60Hz (vedi targhetta caratteristiche) potenza massima assorbita 5600W Questa apparecchiatura è conforme alle seguenti Direttive Comunitarie: 73/23/CEE del 19/02/73 (Bassa Tensione) e successive modificazioni 89/336/CEE del 03/05/89 (Compatibilità Elettromagnetica) e successive modificazioni 93/68/CEE del 22/07/93 e successive modificazioni. G B Cleaning the appliance  Do not use abrasive or corrosive detergents, stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface. [. . . ]