User manual HOTPOINT PF 631 A

[. . . ] Caution: If the burner accidently goes out, turn off the gas with the control knob and try to light it again after waiting at least 1 minute. To turn off a burner, turn the knob in the clockwise direction until it stops (it should be on the “•” setting). electric Hot Plate (only on certain models) The hot plate can be: "normal" and "fast". The latter can be identified by a red boss in the center of the hot plate itself. [. . . ] The electrical system of this appliance is safe only when it is correctly connected to an adequate earthing system, as required by current safety standards. Trying to install or repair the appliance without the assistance of qualified personnel. € • The assistance of qualified personnel must be called upon in the following cases: - Installation (in accordance with the manufacturer's instructions); - When in doubt about the operation of the appliance; - Replacement of the electrical outlet becuase it is incompatible with the plug. Contact service centers authorized by the manufacturer in the following cases: - When in doubt about the condition of the appliance after having removed the packing; - Damage to or replacement of the power supply cord; - In the case of a breakdown or malfunction: ask for original spare parts. It is recommended that you follow the guidelines below: - Only use the appliance to cook food, avoiding all other uses; - Check the condition of the appliance after it has been unpacked; - Disconnect the appliance from the power supply in the event of malfunction and always before cleaning or maintenance; - When not in use, disconnect the appliance from the power supply and turn off the gas valve (if present); - Always check to make sure that the control knobs are on the “•”/”o” setting when the appliance is not in use; - Cut the power supply cord after disconnecting it from the electrical mains when you decide to no longer use the appliance. € The manufacturer will not be held liable for any damages arising out of : incorrect installation or improper, incorrect or unreasonable use. Prevent children and the disabled from coming into contact or having access to the following, as they are possible sources of danger: - The controls and the appliance in general; - The packaging (plastic bags, polystyrene, nails, etc. ); - The appliance, during and immediately after use given the heat generated by its use; - The appliance when no longer in installed (in this case, all potentially dangerous parts must be made safe). The following should be avoided: - Touching the appliance with wet parts of the body; - Using the appliance with bare feet; - Pulling on the appliance or the power supply cord to disconnect them from the electrical outlet; - Improper and/or dangerous use; - Obstructing the ventilation or heat dissipation slots; - Allowing the power supply cord of small appliances to come into contact with the hot parts of the cooktop; - Exposure to atmospheric agents (rain, sun); - Using flammable liquids nearby; - Using adaptors, multiple outlet plugs and/or extensions; - Using unstable or deformed cookware; - Leaving the electric hobs on without cookware on top of them; - Closing the glass top (if present) while the gas burners or electrical hot plates are still hot; 13 Installation Instructions for built-in The following instructions are intended for the installer so that the installation and maintenance procedures may be followed in the most professional and expert manner possible. Important: Disconnect the appliance from the electrical supply before performing any maintenance or regulation upkeep work. Positioning the Cooktop Important: this unit may be installed and used only in permanently ventilated rooms in accordance with British Standard Codes Of Practice: B. The following requirements must be observed: a) The room must be fitted with a ventilation system which vents smoke and gases from combustion to the outside. This must be done by means of a hood or electric ventilator that turns on automatically each time the hood is operated. C) Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e. Opening a window or increasing the power of the air intake system (if present). D) Liquidified petroleum gases are heavier than air and, as a result, settle downwards. Rooms in which LPG tanks are installed must be fitted with ventilation openings to the outside in order to allow the gas to escape in the event of a leak. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. It is also a good idea to keep only the tank currently being used in the room, making sure that it is not near sources of heat (ovens, fireplaces, stoves, etc. ) that could raise the internal temperature of the tank above 50°C. Installation of Built-in Cooktops The gas cooktops are equipped with type X degree protection against overheating. Therefore, the appliance can be installed next to cabinets, provided the height of the cabinet does not exceed that of the hob. [. . . ] If the gas pressure is different than that prescribed, a pressure regulator must be installed at the source, in compliance with national standards governing the use of piped gas regulators. Regulation of Air Supply to the Burner The burners do not need a primary air regulator. minimum Regulation • Turn the gas valve to minimum. € Remove the knob and turn the regulator screw (positioned either on the side of the top or inside the shaft) clockwise until the flame becomes small but regular. [. . . ]