User manual HOTPOINT PH 960 MST

[. . . ] S TC TC 11 Congratualtions on choosing an Ariston appliance, which you will find is dependable and easy to use. We recommend that you read this manual for best performance and to extend the life of your appliance. Close-up View A B A B 12 11 1 2 3 4 5 6 5 4 1 2 3 10 9 8 7 6 C I H A B C G H A B 12 11 1 2 3 4 5 10 9 8 7 6 C L H E C A B A B C C F D A Gas Burners B Support Grid for Cookware C Control Knobs for Gas Burners and Electric Hot Plates D Ignitor for Gas Burners (only on certain models) E Ignition Button for Gas Burners (only on certain models) F Safety Device (only on certain models) - Activates if the flame accidentally goes out (spills, drafts, etc. ), interrupting the delivery of gas to the burner. [. . . ] The flame does not stay lighted on the model with the safety device. Check to make sure that: • You press the knob all the way in; • You keep the knob pressed in long enough to activate the safety device. € The gas holes are not clogged in the area corresponding to the safety device. The burner does not remain on when set to "Low". Check to make sure that: • The gas holes are not clogged. € There are no draughts near the cooking surface. • The minimum has been adjusted correctly (see the section entitled , "Minimum Regulation"). Check to make sure that: • The bottom of the cookware is perfectly flat. • The cookware is centered correctly on the burner or electric hot plate. € The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Never call upon technicians not authorized by the manufacturer, and refuse to accept spare parts that are not original. 16 Safety Is a Good Habit to Get Into To maintain the EFFICIENCY and SAFETY of this appliance, we recommend: • call only the Service Centers authorized by the manufacturer • always use original Spare Parts • • This manual is for a class 3 built-in cooktop. This appliance is designed for non-professional use in the home and its features and technical characteristics must not be modified. These instructions are only valid for the countries the symbols for which appear on the manual and the serial plate. The electrical system of this appliance is safe only when it is correctly connected to an adequate earthing system, as required by current safety standards. Striking the ceramic glass cooking surface (if present) with pointed objects; Closing the glass top (if present) while the gas burners or electrical hot plates are still hot; Trying to install or repair the appliance without the assistance of qualified personnel. - Always check to make sure that the control knobs are on the “•”/”o” setting when the appliance is not in use; - Cut the power supply cord after disconnecting it from the electrical mains when you decide to no longer use the appliance. € The manufacturer will not be held liable for any damages arising out of : incorrect installation or improper, incorrect or unreasonable use. 17 Installation Instructions for built-in The following instructions are directed at the qualified installer so that the installation and maintenance proceedures may be followed in the most professional and expert manner possible. Important: Unplug the electrical connection before performing any maintenance or regulation upkeep work. [. . . ] During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is • That the plug or switch are easily accessible. Connect the Brown wire to the terminal marked “L” or coloured Red. Connect the Blue wire to the terminal marked “N” or coloured Black. [. . . ]