User manual HOTPOINT PK 644 D GH X /HA

[. . . ] Com 10 Operating Instructions HOB Contents Installation, 12-14 IT Italiano, 1 GB GB GB English, 11 FR Français, 20 Positioning Electrical connection Gas connection Burner and nozzle specifications BE Nederlands, 30 ES Español, 40 BE Deutsch, 50 Description of the appliance, 15 Overall view Start-up and use, 16 PT Português, 60 GR ÅëëçíéêÜ, 70 Practical advice on using the burners Data plate Precautions and tips, 17 General safety Disposal PK 644DGH X /HA PKQ 644DGH /HA PK 755DGH X/HA PKQ 755DGH /HA Maintenance and care, 18 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 19 11 Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated 13 GB Connecting a flexible jointless stainless steel pipe to a threaded attachment The gas supply pipe fitting is a threaded 1/2 gas cylindrical male attachment. These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. Checking the tightness of the connection !When the installation process is complete, check the pipe fittings for leaks using a soapy solution. € Adjusting the burners’ primary air : Does not require adjusting. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). 78 MJ/m³ S S A R S R A S A PK 644 D GH X/HA PKQ 644 D GH /HA PK 755 D GH X/HA PKQ 755 D GH /HA 14 Description of the appliance Overall view GB Support Grid for COOKWARE GAS BURNERS Control Knobs for GAS BURNERS GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS Ignition for GAS BURNERS SAFETY DEVICES !The largest slot should be inserted into the ignition. • GAS BURNERS differ in size and power. Use the diameter of the cookware to choose the most appropriate burner to cook with. € Control Knobs for GAS BURNERS adjust the size of the flame. • GAS BURNER ignition enables a specific burner to be lit automatically. € SAFETY DEVICE stops the gas flow if the flame is accidentally extinguished. The position of the corresponding gas burner or electric hotplate* is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: • Off Maximum Minimum To turn on one of the burners, place a lighted match or lighter near the burner, press the knob all the way in and turn it anti-clockwise to the "High" setting. The knob must be pressed in for about 6 seconds until the device that keeps the flame lit warms up. Some models are equipped with an ignition button incorporated into the control knob. If this is the case, the ignitor is present. [. . . ] Do not use stainless steel flame spreaders, bread toasters or meat grills over gas flames. Gas tap maintenance Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. [. . . ]