User manual HOTPOINT PK 750 T GH

[. . . ] ی‬ 52 ،‫نگهداری و مراقبت‬ 52 ،‫عیب یابی‬ ‫عربی‬ ‫تعليمات التشغيل‬ ‫محتويات‬ ‫رف تسخين‬ ‫تعليمات التشغيل،2‬ ‫تحذيرات،5‬ ‫المساعدة،6‬ ‫وصف الجهاز،9‬ ‫التركيب،55‬ ‫التشغيل واالستخدام،85‬ ‫وسائل الحذر والنصائح،16‬ ‫الصيانة والعناية،16‬ ‫استكشاف المشاكل وحلها،06‬ Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Stickers are available from any of our Service Centres. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). replacing the Triple ring burner nozzles 1. Remove the pan supports and lift the burners out of their housing. The burner consists of two separate parts (see pictures). Unscrew the nozzles using a 7 mm socket spanner. Replace the nozzles with models that are configured for use with the new type of gas (see Table 1). The two nozzles have the same hole diameter. Replace all the components by completing the above operations in reverse order. Thanks to this system, gas hobs are also capable of guaranteeing the same cooking results for each recipe, as the optimal power level for the desired type of cooking can be identified in an easier, more accurate way. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: ● Off Maximum Minimum To activate any one of the two rings, press the corresponding knob and turn . It anti-clockwise to the maximum power setting In order to use the double-flame burner to its full potential, avoid simultaneously setting the inner ring to minimum power and the outer ring to maximum power. Ceramic Glass Module* This cooktop is fitted with dual-ring radiant heating elements located beneath the glass. It is possible to turn on only the circular part of the elemement (identified by the letter “A”) or the cooking surface can be enlarged by turning on both “A” and “B”. To turn only the circular “A” element, simply turn the knob in the clockwise direction to any one of the 12 available settings. To add the “B” section, turn the knob to setting 12 and then click it into the setting. Then proceed by turning the knob in the counter-clockwise direction to one of the 12 settings. The figure shows the heating zones, which become red when the element is turned on. Indicator light to show when the cooking zone is above 60°C, even after the heating element has been turned off. When the knob is on any of the settings other than “Off”, the Indicator Light for Ceramic Glass Module comes on. [. . . ] This also protects the surface from damage caused by food with a high sugar content. Do not use abrasive sponges or cleaning products under any circumstances. This holds true for chemically aggressive cleaners, like oven sprays and stain removers. Gas tap maintenance Over time, the taps may become jammed or difficult to turn. [. . . ]