User manual HOTPOINT PKL 741 T/D2/IX/A

[. . . ] PKL 641 D2/IX/A AUS PKL 741 T/D2/IX/A AUS Español Manual de instrucciones ENCIMERA Sumario Manual de instrucciones, 1 Advertencias, 3 Asistencia, 4 Descripción del aparato, 5 Instalación, 22 Puesta en funcionamiento y uso, 27 Precauciones y consejos, 28 Mantenimiento y cuidados, 28 Anomalías y soluciones, 29 English Operating Instructions HOB Contents Operating Instructions, 1 Warnings, 2 Assistance, 4 Description of the appliance, 5 Installation, 6 Start-up and use, 11 Precautions and tips, 12 Maintenance and care, 12 Troubleshooting, 13 Français Mode d’emploi TABLE DE CUISSON Sommaire Mode d’emploi, 1 Avertissements, 2 Assistance, 4 Description de l’appareil, 5 Installation, 14 Mise en marche et utilisation, 19 Précautions et conseils, 20 Nettoyage et entretien, 20 Anomalies et remèdes, 21 Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Stickers are available from any of our Service Centres. inner DRDA (DCDR) burner adjustment 8 !Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). GB Post Installation Checks Perform post installation checks and ensure proper and safe operation before leaving. test all burners individually and in combination. Leak Check • Ensure all gas control knobs are in the Off position. • Ensure the gas supply is switched on. € Spray a solution of soapy water onto all gas joints as well as the full length of any flexible hoses. uNDER NO CIRCUMSTANCES USE A NAKED FLAME IN CHECKING FOR LEAKS. If bubbles appear anywhere, turn the gas supply off, check all connections and retest. If satisfactory operation cannot be achieved, contact place of purchase or their appointed agent for service. Flame check Turn each burner on, and ensure that the flame is blue with minimal yellow tipping. If there is significant yellow tipping, flame lift off or excessive noise, check pressure and adjust at the regulator if necessary. If satisfactory operation cannot be achieved, contact place of purchase or their appointed agent for service. Igniter operation Check that the igniter for each burner successfully ignites the gas. If an igniter fails to work, first remove the plug from the electrical power outlet, and then check that all the electrical connections are in place. If satisfactory operation cannot be achieved, contact place of purchase or their appointed agent for service. Low flame setting Check the low flame setting for each hob burner to ensure that the minimum flame will not be extinguished by air draughts. [. . . ] If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. Troubleshooting It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. [. . . ]