User manual HOTPOINT RO 642 TOIRFH

[. . . ] Operating Instructions HOB Contents G B English, 1 GB R S Русский, 14 Installation, 2-4 Positioning Electrical connection Description of the appliance, 5-6 Control panel Extendable cooking zones Start-up and use, 7-10 Switching on the hob Switching on the cooking zones Switching off the cooking zones Power function Heating elements Programming the cooking duration Timer Control panel lock Switching off the hob “Demo” mode Practical advice on using the appliance Safety devices Practical cooking advice 7HKRO 642 D X RU/HA 7HKRO 642 D Z RU/HA 7HKRO 642 TO B RU/HA 7HKRO 642 TO Z RU/HA 7HKRO 642 TO X RU/HA 7HKRO 642 DO X RU/HA CRO 642 TO X RU/HA Precautions and tips, 11 General safety Disposal Care and maintenance, 12 Switching the appliance off Cleaning the appliance Disassembling the hob Technical description of the models, 13 Installation !Before operating your new appliance please read GB this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. Please keep these operating instructions for future reference. [. . . ] Radiant elements consist of a series of coils which allow heat to be distributed evenly at the base of the cookware, so that all slow-flame cooking may be performed successfully, for example stews, sauces or reheated dishes. Button is pressed for an extended period of time, the display scrolls quickly though the power levels and timer minutes. Switching on the hob To switch the hob on, press and hold the for approximately one second. Button Switching on the cooking zones Each cooking zone is controlled using a selector button and a power adjustment device consisting of power level selector buttons between the values of 0 and 9. € To begin operating a cooking zone, press the corresponding control button and set the desired power level using the power level selector buttons between 0 and 9. All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. At step 2, press the - button: the + and buttons duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. Release the press the button; Timer The hob must be switched on. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer . + and buttons and • The display will show the text DE and MO and the hob will be switched off. € When the hob is switched on again it will be set to the “demo” mode. To exit this mode, follow the procedure described above. The display will show the text DE and OF and the hob will be switched off. When it is next switched on, the hob will function normally. Set the desired duration using the buttons. [. . . ] 11 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. If water is spilt on the surface, dry it quickly and thoroughly. [. . . ]