User manual HOTPOINT RSSF 704 J PL

[. . . ] 12 Instructions for use WASHING MACHINE Contents GB English GB Installation, 14-15 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 16 Cutting off the water and electricity supplies Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 17 General safety Disposal Opening the porthole door manually RSSF 704 J Description of the washing machine, 18-19 Control panel Display Running a wash cycle, 20 Wash cycles and options, 21 Table of programmes and wash cycles Wash option Detergents and laundry, 22 Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system Troubleshooting, 23 Service, 24 13 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/ herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] dIRECT INJECTION button and indicator light: press to select the DIRECT INJECTION option. dOOR LOCKED indicator light: The lit symbol indicates that the door is locked. To prevent any damage, wait until the symbol turns off before opening the door. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened. Press the button; the START/PAUSE indicator light will flash slowly in a green colour. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes and wash cycles on the following page. Pull out the detergent dispenser drawer and pour the detergent into the relevant compartments as described in “Detergents and laundry”. Use the WASH CYCLE SELECTOR knob to select the desired wash cycle. A temperature and spin speed is set for each wash cycle; these values may be adjusted. The duration of the cycle will appear on the display. Use the relevant buttons: Modify the temperature and/or spin speed. The machine automatically displays the maximum temperature and spin speed values set for the selected cycle, or the most recently-used settings if they are compatible with the selected cycle. The temperature can be decreased by pressing the button, until the cold wash “OFF” setting is reached. The spin speed may be progressively reduced by pressing the button, until it is completely excluded (the “OFF” setting). If these buttons are pressed again, the maximum values are restored. Exception: if the 2 programme is selected, the temperature can be increased up to a value of 40°C. Exception: if the 3 programme is selected, the temperature can be increased up to a value of 90°C. Exception: if the 4 programme is selected, the temperature can be increased up to a value of 60°C. To set a delayed start for the selected cycle, press the corresponding button repeatedly until the required delay period has been reached. When this option has been activated, the symbol lights up on the display. To remove the delayed start setting, press the button until the text “OFF” appears on the display. €¢ Press the button to enable the option; the indicator light corresponding to the button will switch on. [. . . ] €¢ The pressure is too low. • The START/PAUSE button has not been pressed. The washing machine continuously • The drain hose is not fitted at a height between 65 and 100 cm from the floor takes in and drains water. (see “Installation”). [. . . ]