User manual HOTPOINT SL M07 A3E O

[. . . ] € • 11 en SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED • Before using the appliance, read these safety instructions. These instructions are also available on www. Eu • These instructions and the appliance itself provide important safety warnings, to be observed at all times. The manufacturer declines any liability for failure to observe these safety instructions, for inappropriate use of the appliance or incorrect setting of controls. [. . . ] CLEANING AND MAINTENANCE Before cleaning or maintaining the vacuum cleaner, make sure it has been unplugged from the electrical outlet. Do not use aggressive substances or abrasive materials to clean the appliance, its internal parts and attachments. Use a dry or slightly damp soft cloth for cleaning. Make sure the appliance and all its parts are thoroughly dry before restart the appliance. We suggest to clean the filter at least every 6 months to restore its filtering power. In any case we recommend replacing the filter at least every year to ensure maximum performance. Always operate the vacuum cleaner with the filter installed. FEATURES Dustbin full indicator (28): the led switch on when the dustbin is full or in case of clogging. After cleaning the dustbin or unclogging, the led will automatically switch off. Filter Cleaning Indicator (29): after used about 50 hours the led switch on. After cleaning (see chapter “Cleaning and maintenance”), to reset the indicator press the symbol “+” (24) of Remote Power Control some seconds. Standby indicator (30): when you use the standby button (26) on the Remote Power Control, the suction power stops and the electronic power regulator (31) blinks one time. To restart the suction power press the standby button (26). Electronic power regulator (31): when press this button the suction power works cyclically (min -> med -> max -> min). It allows to set the suction power required. Led indicators (28, 29, 30) and Electronic power regulator (31) (if available) Cleaning the dustbin For the routine cleaning of the dustbin (E): 1. Press the dustbin release button (36) on the handle (23) and take out the dustbin. Keep the dustbin in vertical position with the lid facing down. Press the lock of dustbin lid (19) to open the dustbin (21). Close the dustbin lid until it clicks into place and replace it into the main body. For the washing of dustbin to remove any residual dirt (C) 1. Before washing the dustbin container, make sure it has been emptied. [. . . ] If the product is in park position with the Start&Pause function (if available) remove the brush from housing and press the Start/Stop button. Clean the filters and, if needed, replace them. Make sure the expansion pipe, flexible hose and brush are not blocked. Clean the filters and, if needed, replace them. [. . . ]