User manual HOTPOINT STM 1511/HA

[. . . ] If the floor is not perfectly horizontal, adjust the refrigerator by tightening or loosening the front feet. Electrical connections After the appliance has been transported, carefully place it vertically and wait at least 3 hours before connecting it to the electricity mains. Before inserting the plug into the electrical socket ensure the following: • The appliance is earthed and the plug is compliant with the law. • The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. [. . . ] • The maximum quantity of food that may be frozen daily is indicated on the plate containing the technical properties located on the bottom left side of the refrigerator compartment (for example: Kg/ 24h: 4) !If there is a power cut or malfunction, do not open the freezer door. This will help maintain the temperature inside the freezer, ensuring that foods are conserved for at least 9 -14 hours. If the room temperature drops below 14°C for an extended period of time, the ideal temperature will not be reached in the freezer compartment and food preservation will be reduced. Butter and margarine On the shelf provided Bottles, drinks, milk On the shelf provided 12 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. Special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. GB Defrosting the freezer compartment If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Set the TEMPERATURE ADJUSTMENT knob to the position . Wrap frozen foods in newspaper and place them in another freezer or in a cool place. Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment. Clean and dry the freezer compartment carefully before switching the appliance on again. Until the ideal storage conditions have been restored, before placing food in the freezer compartment. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. • The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. [. . . ] This shows the appliance is operating normally. Some of the external parts of the refrigerator become hot. The back wall of the refrigerator unit is covered in frost or droplets of water. There is water at the bottom of the refrigerator. [. . . ]