User manual HOTPOINT TB 050 DSL0

[. . . ] To disconnect, turn any control to “off”, then remove plug from wall outlet by grasping the plug, not the cord. To reduce the risk of injury, never place blade assembly on motor unit without the jar properly attached. O not leave the D machine on unattended. Hen removing the W blender from the motor unit, wait until the blades have completely stopped. [. . . ] Holding the jar handle, invert the jar onto a level surface, put the jar base onto the jar bottom and secure the jar base by turning it clockwise until tight (See Fig. Place the gasket 2 and the blade assembly onto the jar and secure the jar base by turning it anticlockwise until tight (See Fig. Place the jar assembly with its opening upwards. Wrap the gasket 1 around the lid bottom and put the lid onto the jar assembly. Place the measure cup exactly into the lid by fitting the small projection on the both sides of the cup into the slots of the lid and turning the cup clockwise until tight. Finally, place the assembled jar onto the motor unit by aligning the arrow symbol on the jar base to the unlock symbol on the motor unit and turning the jar clockwise until tight. Attention: Do not try to twist the jar and jar base onto motor unit. Peel or pit fruit or vegetables and then cut it into small dices. Place the food to be blended into the jar (See Fig. The suggested proportion of the food and water is 2:3. The amount of mixture should not exceed the max level as indicated on the jar. Attention: never use boiling liquids or run the appliance empty. Plug the power cord into a standard wall outlet. Turn the speed knob to the selected speed. For quick or delicate blending tasks, turn the speed knob to P position and hold for a few seconds and then release; the knob will reset to 0 position automatically. Operate several times until the desired consistence. If you want to add ingredients while the blender is working, remove the measuring cup and place through the lid opening. When crushing ice or hard food, keep one hand firmly on the lid. When the consistence you desire is obtained, 13 en it turn the knob to 0 position. Note: For each use, the consecutive operation time should not exceed 3 minutes. At least 10 minutes rest time must be maintained between two continuous cycles. In any case, let the unit cool to room temperature before performing next operation cycle. [. . . ] Always wash immediately after use for easier cleaning. Don’t let food dry on the jar assembly as this will make cleaning difficult. Pour a little warm soapy water into the jar and turn the knob to P position for a few seconds and then empty the jar. Lift the jar assembly off the motor unit, detach the blade assembly by turning it clockwise from the jar base bottom , and remove the gasket 2 and blade assembly (See Fig. [. . . ]