User manual HOTPOINT TCD 871 6HY1

[. . . ] Instruction booklet GB English, 1 I Italiano, 20 F Français, 39 Contents Installation, 2-3 Where to put your dryer Ventilation Water drain Levelling Electrical connection Before you start using your dryer GB D Deutsch, 58 NL Nederlands, 77 Warnings, 4-5 General safety To minimise the risk of fire Maintenance and Care, 6-7 Switching off the electricity Cleaning the filter after each cycle Cleaning the heat pump filter unit Empty the water container after each cycle Check the drum after each cycle Cleaning the dryer TCD 871 First time you turn on your dryer you must select your preferred language see page 9 Dryer description, 8 The features Control panel TUMBLE DRYER This symbol reminds you to read this booklet. Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how the appliance works. Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works. [. . . ] The Standard Cotton programme to EU Regulation 392/2012 is Programme 1 selection with High Heat and Dryness Level Cupboard Dry. Shirts Cotton This is a programme for shirts made from cotton. — It can be used for load sizes up to 3kg (approximately 10 shirts). The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer. Loads dried using the Cupboard Dry setting are usually ready to wear, the edges or seams may be slightly damp. If this is the case, try turning the shirts inside out and running the programme again for a short period. ● ● ● ● Bed & Bath This is a programme for cotton towels and sheets. The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer (see Laundry). Loads dried using the Extra Dry setting are usually ready to use, the edges or seams may be slightly damp especially on large items. If this is the case, try opening them out and running the programme again for a short period. Anti Allergy Programme This programme has the ‘Seal of Approval’ endorsement from Allergy UK, which reflects the effective reduction and elimination of allergens from the clothes with the special Anti Allergy cycle. With this programme, thanks to the achievement of constant temperature for an extended period of time, the effects of the most common allergens (including House Mites and Pollen) are neutralised. Can be used on a full size wet load to dry and treat, or on a 4kg dry load just to treat your laundry. If the display shows CLEAN FILTER TO ENSURE ANTI ALLERGY ACTION : Clean the filter and re-start the programme. Synthetics This is a programme for items of Synthetic with low heat setting or Synthetic/Cotton mixtures with medium heat setting. The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer (see Laundry). — ● Shirts Synthetic This is a programme for shirts made from synthetic materials or a mixture of natural and synthetic materials, such as polyester and cotton. — It can be used for load sizes up to 3kg (approximately 14 shirts). The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer. Loads dried using the Cupboard Dry setting are usually ready to wear, the edges or seams may be slightly damp. If this is the case, try turning the shirts inside out and running the programme again for a short period. ● 12 Extra Dry Light Dry Iron Dry Start and Programmes EXCLUSIVE PROGRAMMES - Programmes Table ! [. . . ] Before calling the Service Centre: ● ● Use the troubleshooting guide to see if you can solve the problem yourself (see Troubleshooting). If not, turn off the dryer and call the Service Centre closest to you. What to tell the Service Centre: name, address and post code. This information can be found on the data label inside the door of the machine. [. . . ]