User manual HOTPOINT TCD G51 AX

[. . . ] The Display, 9-11 Start and programmes, 11-14 Choosing a programme Programmes Table The Controls Laundry, 15 Sorting your laundry Wash care labels Drying times Troubleshooting, 16 Service, 17 Spare Parts Product data, 18 Recycling and Disposal www. Eu 1 Installation GB Where to put your dryer Place your dryer at a distance from gas ranges, stoves, heaters, or cook tops because flames can damage the appliance. The dryer should be installed in an ambient room temperature of between 20 to 23˚C for optimum performance. But will function if the room is between 14 and 30˚C. [. . . ] eMPTY WATER BOTTLE ● Indicates that the water container is full. The message will take a few seconds to go out after replacing the empty water container; the dryer must be running for this to happen (see The Controls). Note: If the water container fills and this message is displayed, the heat is turned off and your clothes will not dry. — CLEAN CONDENSER, FILTER AND EMPTY WATER BOTTLE This message indicates that you must clean the Heat Pump Condenser Filter unit (see Maintenance) and will occur at intervals depending how much you have used the dryer. When you finish the next programme the message is cancelled. start and Programmes Choosing a programme 1. Plug the dryer into the electrical socket. Sort your laundry according to fabric type (see Laundry). Open the door and make sure the filter is clean and in place and the water container is empty and in place (see Maintenance). Load the machine and make sure items are not in the way of the door seal. If the Display is not lit: Press the ON/OFF button 6. It can be used for load sizes up to 3kg (approximately 10 shirts). Medium heat option This is a programme for shirts made from synthetic materials or a mixture of natural and synthetic materials, such as polyester and cotton. It can be used for load sizes up to 3kg (approximately 14 shirts). The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer. Loads dried using the Cupboard Dry setting are usually ready to wear, the edges or seams may be slightly damp. If this is the case, try turning the shirts inside out and running the programme again for a short period. Synthetics ● ● This is a programme for items of Synthetic with low heat setting or Synthetic/Cotton mixtures with medium heat setting. The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer (see Laundry). bed & Bath ● ● ● This is a programme for cotton towels and sheets. The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer (see Laundry). Loads dried using the Extra Dry setting are usually ready to use, the edges or seams may be slightly damp especially on large items. [. . . ] spare Parts This dryer is a complex machine. Repairing it yourself or having a non-authorised person try to repair it could cause harm to one or more persons, could damage the machine and could invalidate the spare parts warranty. Call an authorised technician if you experience problems while using the machine. Please note: it is an offence for an unqualified person to undertake any servicing or repair work that involves breaking into the sealed heat pump unit. [. . . ]