User manual HOTPOINT TCF 87B 6H

[. . . ] Instruction booklet TUMBLE DRYER GB English, 1 F Français, 18 D Deutsch, 35 Contents Important information, 2-3 Installation, 4 Where to put your dryer Ventilation Water drain Electrical connection Before you start using your dryer GB E Español, 52 P Português, 69 Dryer description, 5 The features Control panel The Display, 6 Start and programmes, 7-11 Choosing a programme Programmes and Tables The controls TCF 87B Laundry, 12-13 Sorting your laundry Wash care labels Special clothing items Drying times Warnings and Suggestions, 14 General safety Saving energy and respecting the environment Maintenance and Care, 15 Switching off the electricity Cleaning the filter after each cycle Check the drum after each cycle Empty the water container after each cycle Cleaning the condenser unit Cleaning the dryer Troubleshooting, 16 Service, 17 Disposal !Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how the appliance works. Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works. [. . . ] Do not load more than the maximum capacity. These numbers refer to the dry weight: Fabric Maximum load Cotton and Cotton mixtures 2. Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put them away in the closet. Should this not be possible repeat the programme. The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel®. €Refresh’ is not a drying programme and should not be used for wet articles of clothing. It can be used on any load size but is more effective on smaller loads. — Do not overload your dryer (see Laundry). — This is a 20 minute programme that airs your clothes with cool air. Select the new programme and any options required, the light will then flash green. Press the START/PAUSE button again and the new programme will start. — The display shows either the amount of time delay remaining or an indication of the amount of time left for a drying programme (see The Display). The colons between the hours and minutes in the display flash to show that the time is counting down. When the programme finishes its cool tumble phase the display will show ‘End’. GB ● Empty Water Icon / Container OPTION buttons / lights These buttons are used to customise the selected programme to your requirements. ● 10 Extra Dry Light Dry Iron Dry Sound Start and Programmes The Controls Programmes knob ● ● DISPLAY 8:88 !Not all options are available for all programmes (see Start and Programmes). If an option is not available and you press the button, the buzzer will beep three times. If the option is available the option light in the button lights to confirm the selection. After the START/PAUSE button has been pressed only the Sound option (where available) can be changed. Progress ( Drying, Cool Tumble) icons These are part of the Display, they indicate the progress of the dryer. [. . . ] Empty water icon is on and the water container is not full. Programme finishes and clothes are damper than expected. For safety the dryer has a maximum programme time of 4 hours. Check the above points and run the programme again, if the results are still damp, contact the Service Centre (see Service). [. . . ]