User manual HOTPOINT TD 640 MS

[. . . ] On those models fitted with an ignitor (D), to light a burner, simply press the corresponding knob all the way in and then turn it in the counter-clockwise direction to the "High" setting, keeping it pressed in until the burner lights. Caution: If the burner accidently goes out, turn off the gas with the control knob and try to light it again after waiting at least 1 minute. To turn off a burner, turn the knob in the clockwise direction until it stops (it should be on the “•” setting). electric Hot Plates (only on certain models) The hot plates vary in diameter and power: "normal" and "fast". [. . . ] This appliance is designed for non-professional use in the home and its features and technical characteristics must not be modified. These instructions are only valid for the countries the symbols for which appear on the manual and the serial plate. The electrical system of this appliance is safe only when it is correctly connected to an adequate earthing system, as required by current safety standards. Using adaptors, multiple outlet plugs and/or extensions; Using unstable or deformed cookware; Leaving the electric hobs on without cookware on top of them; The top made is resistant to sudden temperature changes and shocks. However, if it is struck with pointed utensils or objects such as cutting knives, it may crack or break. If this occurs, disconnect the appliance immediately from the power supply and contact an authorised service centre. Trying to install or repair the appliance without the assistance of qualified personnel. € • Prevent children and the disabled from coming into contact or having access to the following, as they are possible sources of danger: - The controls and the appliance in general; - The packaging (plastic bags, polystyrene, nails, etc. ); - The appliance, during and immediately after use given the heat generated by its use; - The appliance when no longer in installed (in this case, all potentially dangerous parts must be made safe). The following should be avoided: - Touching the appliance with wet parts of the body; - Using the appliance with bare feet; - Pulling on the appliance or the power supply cord to disconnect them from the electrical outlet; - Improper and/or dangerous use; - Obstructing the ventilation or heat dissipation slots; - Allowing the power supply cord of small appliances to come into contact with the hot parts of the cooktop; - Exposure to atmospheric agents (rain, sun); - Using flammable liquids nearby; 11 - The assistance of qualified personnel must be called upon in the following cases: - Installation (in accordance with the manufacturer's instructions); - When in doubt about the operation of the appliance; - Replacement of the electrical outlet becuase it is incompatible with the plug. Contact service centers authorized by the manufacturer in the following cases: - When in doubt about the condition of the appliance after having removed the packing; - Damage to or replacement of the power supply cord; - In the case of a breakdown or malfunction: ask for original spare parts. It is recommended that you follow the guidelines below: - Only use the appliance to cook food, avoiding all other - - uses; Check the condition of the appliance after it has been unpacked; Disconnect the appliance from the power supply in the event of malfunction and always before cleaning or maintenance; When not in use, disconnect the appliance from the power supply and turn off the gas valve (if present); - • Always check to make sure that the control knobs are on the “•”/”o” setting when the appliance is not in use; Cut the power supply cord after disconnecting it from the electrical mains when you decide to no longer use the appliance. The manufacturer will not be held liable for any damages arising out of : incorrect installation or improper, incorrect or unreasonable use. Installation Instructions for built-in The following instructions are intended for the installer so that the installation and maintenance procedures may be followed in the most professional and expert manner possible. Important: Disconnect the appliance from the electrical supply before performing any maintenance or regulation upkeep work. Positioning the Cooktop Important: this unit may be installed and used only in permanently ventilated rooms in accordance with British Standard Codes Of Practice: B. The following requirements must be observed: a) The room must be fitted with a ventilation system which vents smoke and gases from combustion to the outside. This must be done by means of a hood or electric ventilator that turns on automatically each time the hood is operated. detail A Adjacent Room Room to be Vented A Examples of ventilation holes for comburant air. Enlarging the ventilation slot between window and floor. B c) Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e. Opening a window or increasing the power of the air intake system (if present). [. . . ] If the gas pressure is different than that prescribed, a pressure regulator must be installed at the source, in compliance with national standards governing the use of piped gas regulators. Regulation of Air Supply to the Burner The burners do not need a primary air regulator. € Remove the knob and turn the regulator screw (positioned either on the side of the top or inside the shaft) clockwise until the flame becomes small but regular. : In the case of liquid gas, the regulation screw must be fully screwed in (clockwise). [. . . ]