User manual HOTPOINT TQG 752 W/HA(ICE)

[. . . ] Operating Instructions, 1 Warnings, 3 Assistance, 8 Description of the appliance, 10 Installation, 19 Start-up and use, 23 Precautions and tips, 23 Maintenance and care, 24 Troubleshooting, 24 WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. Checking the tightness of the connection !When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Remove the hob grids and slide the burners off their seats. Unscrew the nozzles using a 7 mm socket spanner, and replace them With nozzles for the new type of gas (see table 1 "Burner and nozzle characteristics"). In the case of the Mini WOK burner, use a spanner with a 7 mm opening to unscrew the nozzle (see figure). The cable must not be bent or compressed. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one Indicating the new type of gas used. Sticker are available from any of our Service Centres. Adjusting the burners' primary air Does not require adjusting. Turn the tap to the low flame position; 2. Remove the knob and adjust the adjustment screw, which is positioned In or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is Alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. Some appliances have a safety device (thermocouple) fitted. [. . . ] Clean with warm water and neutral detergent, and then dry with a soft cloth or chamois. Remove baked-on dirt with specific cleaners for stainless steel surfaces. Clean stainless steel only with soft cloth or sponge. Clean the enamelled and glass parts only with soft cloth or sponge. [. . . ]