User manual HOTPOINT TVF 63 X

[. . . ] Install the clothes dryer according to the manufacturer’s instructions and local codes. Do not install a clothes dryer with flexible plastic venting materials. If flexible metal (foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with clothes dryers. Flexible venting materials are known to collapse, be easily crushed and trap lint. [. . . ] When the program is selected the display shows the time required to dry a full load, after around 10 minutes the controller calculates a better estimate of the cycle time. The colons between the hours and minutes in the display flash to show that the time is counting down. When the program finishes its air fluff phase the display will show E88 . The display also shows if there is a problem with your dryer, if this occurs the display will show F followed by a fault code number (see Troubleshooting). Q Door Opening Opening the door (or pressing the Start/Pause button ) during a program will stop the dryer and have the following effects: q The Start/Pause light flashes amber. Q During a delay phase the delay will continue to count down. The Start/Pause button must be pressed to resume the delay program. The progress lights will change to show current status. Q During the drying part of the program, the time to end count continues but the colons do not flash. The Start/Pause button must be pressed to resume the program. The progress lights will change to show the current status. Q During the post care phase of a drying program the program will finish. Pressing the Start/Pause button will re-start a new program at the beginning. Q The Start/Pause button must be pressed to resume the program. The progress lights will change to show the current status and the Start/Pause light will stop flashing and turn green. Q Changing the Programs knob will select a new program and the Start/Pause light will flash green. You can use this to select the Air Fluff program to cool the clothes, if you find them dry enough. Press the Start/Pause button to begin a new program. Q Note If you have a power outage, switch off the power or remove the plug, press the Start/Pause button and the program will resume. 9 Laundry EN Sorting your laundry q Wash Care Labels Look at the labels on your garments, especially when tumble drying for the first time. The following symbols are the most common: May be tumble dried Do not tumble dry Tumble dry at high heat setting q q q q Check symbols on clothing labels to make sure that the articles can be tumble dried. Close zippers and hooks and tie loose belts and strings. [. . . ] 15 ARISTON ONE-YEAR LIMITED WARRANTY (USA & CANADA ONLY) EN WHO IS COVERED BY THIS WARRANTY This limited one-year warranty ("Warranty") is given only to the original end-use/retail purchaser (the "First Using Purchaser") of the accompanying Ariston product(s) (the "Ariston Product"). If you purchased this Ariston Product from someone other than an authorized Ariston reseller/dealer in the United States or Canada, or if the Ariston Product was used (including but not limited to floor models or refurbished products) prior to your purchase, then you are not the First Using Purchaser and the Ariston Product that you purchased is not covered by this Warranty. WHAT IS COVERED BY THIS WARRANTY Ariston will repair or replace any part of the Ariston Product which fails due to a defect in materials or workmanship when used under normal home-use conditions. Ariston will also provide, free of charge, all labor to repair or replace the defective part. [. . . ]