User manual HOTPOINT XBC 902 GH DC/HA

[. . . ] 10 Operating Instructions HOB GB IT Italiano, 1 GB English, 11 FR Français, 21 Contents Installation, 12-15 Positioning Electrical connection Gas connection Data plate Burner and nozzle specifications DE Deutsch, 31 NL Nederlands, 41 Description of the appliance, 16 Overall view Start-up and use, 17 Practical advice on using the burners Precautions and tips, 18 XBC 902 GH DC/HA General safety Disposal Maintenance and care, 19 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 20 11 Installation GB !Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Stickers are available from any of our Service Centres. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). Unscrew the burers with a 7 mm wrench spanner. The internal burner has a nozzle, the external burner has two (of the same size). Replace the nozzle with models suited to the new type of gas (see table 1). Replace all the components by repeating the steps in reverse order • Adjusting the burners’ primary air : Does not require adjusting. • Setting the burners to minimum: 1. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. Some appliances have a safety device (thermocouple) fitted. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. The hob can only be installed above built-in ovens with a cooling ventilation system. B D B A C 15 Description of the appliance GB Overall view GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS SAFETY DEVICES Ignition for GAS BURNERS • GAS BURNERS differ in size and power. Use the diameter of the cookware to choose the most appropriate burner to cook with. € Control Knobs for GAS BURNERS adjust the power or the size of the flame. • GAS BURNER ignition enables a specific burner to be lit automatically. € SAFETY DEVICE stops the gas flow if the flame is accidentally extinguished. The position of the corresponding gas burner is shown on every knob. Since the burner is equipped with a safety device, after lighting the burner keep the knob pressed in for about 2-3 seconds to allow the device which keeps the flame lit automatically to heat up. [. . . ] After cleaning, rinse and dry any remaining drops of water. Gas tap maintenance Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. [. . . ]