User manual HP 2309V SETUP

[. . . ] this document contains proprietary information that is protected by copyright. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of HP. May be licensed in the United States by one or both of U. HP supports lawful use of technology and does not endorse or encourage the use of our products for purposes other than those permitted by copyright law. [. . . ] When turning on the TV for the first time, a first-time setup wizard walks you through the following: Control to enter a year, month, and day. Perform the following steps before you press TV Power on the remote control unit. 6 Use the left and down arrow buttons to change Low power: Power-up time from standby is approximately 20 seconds. However, the TV is consuming less power while in standby. fast power: Power-up time from standby is approximately 5 seconds. However, the TV consumes more power while in standby. 1 Select from among three languages: English, Remote control to select the desired language listed on the screen, and then press OK. This channel search operation automatically searches for a signal from all available channels. You can start the first-time setup wizard by using the System menu in the onscreen display (OSD); see "Starting the Setup Wizard" on page 40. 5 Press the down button to highlight the time field, And use the number pad to enter the time. 1 Press and open the cover on the back of the Make sure that you match polarities. Use these number buttons to edit or enter a display name for an analog channel using the Channel menu; see "Displaying channel information" on page 32. M ­ (Dash) Press ­ (dash) to enter a dash for a subchannel number of a digital channel. Press Info to view a channel banner containing information on your current program. Press Ant again to view TV if currently viewing DVD or other source. Press Ant to view a channel banner containing information on your current program. To select a channel, enter a one-digit, two-digit, or three-digit number, or use the channel up or down buttons. To select a channel number (for example, channel 25), complete the following procedure within 4 seconds: 2 Press the Mute button again to restore the sound To select a subchannel number (for example, 14-2): Keep pressing the Picture button or right arrow to change the video mode until you reach a desired picture. Standard: Good for normal viewing conditions with low room lighting. For more information on defining the picture settings, see "Using the Picture Menu" on page 28. Press the Last button on your remote control to view the previous channel you were viewing. Pressing the Info button displays a banner with information about the current program you are viewing. [. . . ] The picture may look dark in a room that is too bright. If watching a component device, make sure the red, blue, and green cables are fully inserted into the proper connectors on both ends. Remove any objects blocking the vent, or clean the vent. Symptom I get a poor picture with video signal input. [. . . ]