User manual HP 71 17 INCH MPRII MONITOR

[. . . ] Connect the monitor only to a grounded power outlet. Use the power cord supplied with the monitor or one with a properly grounded plug. [. . . ] If the displayed image appears to be rotated If the vertical edges appear to curl in or out If the vertical edges appear to curl to the left or right If the vertical edges do not appear parallel Wenn die Bildschirmanzeige gedreht erscheint. Anti-glare, anti-static multi-layer coating, Horizontal 30 to 70kHz Vertical 50 to 120 Hz 1280 x 1024 (60Hz) 30 minutes to reach optimum performance level 110 MHz Maximum Size: 324(W) x 243(H) mm AC 100 to 240 V, 50 to 60 Hz, Current 2A On 100W (max) LED : green Standby mode 15W (max) Suspend mode 5W (max) Active Off 5W (max) Off 5W (max) Temperature Humidity LED : constant amber LED : blinking amber LED : blinking amber LED : blinking amber -5 °C to 40 °C 20% RH through 90% RH (without condensation) -20 °C to 60 °C 10% RH through 85% RH (without condensation) Cabinet Dimensions 420(W) x 452(H) x 432 (D) mm with stand Weight 16 Kg Tilt/Swivel Stand Tilt Angle Swivel Angle -5° to 15° -45° to +45° Color temperature of your monitor Displays current setting for horizontal frequency, refresh rate and resolution when highlighted. Your monitor is automatically demagnetized each time it is switched ON. To maintain color purity, we recommend that each week you switch the monitor off for at least 30 minutes before switching it on again. Duc declares, that the product: oduc HP 17" Color Monitors Product Name: D8901A, D8902A Model Number: ode conforms to the following product specifications: SAFETY - International: IEC 60950:1991 + A1 + A2 +A3 +A4 / GB4943-1995 - Europe: EN 60950:1992 + A1 + A2+A3 + A4 - CISPR 22:1993+A1 + A2 / EN 55022:1994 + A1 +A2 Class B1) EMC - EN 50082-1:1992 IEC 801-2:1992 / prEN 55024-2:1992 - 4kV CD, 8 kV AD IEC 801-3:1984 - 3V/m IEC 801-4:1988 / prEN 55024-4:1992 - 1 kV Power Lines - IEC 555-2:1982 + A1:1985 / EN 60555-2:1987 - IEC 61000-3-3:1994 / EN 61000-3-3:1995 - GB9254-1988 - FCC Title 47 CFR, Part 15 Class B2) - ICES-003, Issue 2 - VCCI-B - AS/NZ 3548:1992 Supplementary information: The product herewith complies with the requirements of the following Directives and carries the CE-marking accordingly: EMC Directive 89/336/EEC and the Low Voltage Directive 73/23/EEC, both amended by the Directive 93/68/EEC. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Federal Communications Commission (FCC) Radio Frequency Interference Statement (USA Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protections against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try one of more of the following measures: · Move the computer away from the radio or television. Plug the computer into a different electrical outlet, so that the computer and the radio or television are on separate electrical circuits. Make sure that all your peripheral devices are also FCC Class B certified. Make sure you use only shielded cables to connect peripheral devices to your computer. [. . . ] The HP Color Monitor has been tested according to MPR 1990:8 for Emission properties and meets the guidelines as given by MPR 1990:10 (2. This Class "B" digital apparatus complies with Canadian ICES-003. [. . . ]