User manual HP 72 17 INCH COLOR MONITOR

[. . . ] hp 72 d8904 - d8905 17-inch color monitor 15. 9-inch viewable image user's guide www. hp. com/go/monitors Notice The information contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. Hewlett-Packard assumes no responsibility for the use or reliability of its software on equipment that is not furnished by Hewlett-Packard. [. . . ] In this mode, the monitor's front panel indicator light is amber. · Active off mode2 (uses less than 5W). In this mode, the monitor's front panel indicator light is amber. To set these power saving modes, refer to the manual that came with your computer. If your screen is not displaying an image, check the front panel indicator light first as your monitor may be in a power saving mode. · 1. Suspend mode is activated when vertical sync is cut by the video controller. 2. Active off mode is activated when both vertical and horizontal sync are cut by the video controller. EnglishEnglish 9 HP 17" Color Monitor User's Guide Troubleshooting Troubleshooting Before calling Hewlett-Packard check the following items: No picture and LED is off. · · · · Check if monitor is switched ON. Check if power cord is properly connected. Check if electrical outlet is connected. Test if monitor works on another computer previously set to monitor's supported resolution. No picture and LED is on. · · · · · Check if monitor is not in power saving mode. Adjust contrast and brightness through the On-Screen Menu (OSD) using the control buttons. Test if monitor works on another computer previously set to monitor's supported resolution. Colors are not pure. · · Degauss your monitor. Shut down your monitor and switch it on after 30 minutes. Picture is not centered. · Adjust picture through the On-Screen Menu (OSD) using the control buttons. Picture is fuzzy. · · · Use the Recall function. Reduce contrast through the On-Screen Menu (OSD) using the control buttons. Adjust moire reduction to zero. 10 EnglishEnglish HP 17" Color Monitor User's Guide Technical Specifications Technical Specifications Size PICTURE TUBE Phosphorous Dot pitch Face Plate Video Synchronization INTERFACE SCANNING FREQUENCY DISPLAY SIZE MAX RESOLUTION RECOMMENDED RESOLUTION WARM-UP TIME PIXEL CLOCK POWER SOURCE OPERATING ENVIRONMENT Input Connector 17-inch flat square tube 15. 9-inch viewable image (15, 9") Red, Green, Blue P22 (medium short persistence) 0. 27mm (0, 27mm) Anti-glare, anti-static, screen coating 0. 7V p p analog RGB (0, 7V) TTL level separate synchronization (negative/positive) 15-pin mini D-SUB INPUT SIGNAL Horizontal 30 to 95 kHz Vertical 50 to 160 Hz 324 x 243 mm ±1mm maximum viewable size 1280 x 1024 (60Hz) 1024 x 768 (85 Hz) 30 minutes to reach optimum performance level 203 MHz AC 100 to 240 V, 50 to 60Hz Current 1. 5 A (1, 5A) Temperature Humidity 0°C to 40°C 10% RH through 80% RH (without condensation) CABINET DIMENSIONS 451 (H) × 420 (W) × 430 (D) mm (including pedestal) WEIGHT TILT/SWIVEL STAND 15Kg - 5° to +13. 5° (13, 5°) ±45° < 75W < 15W < 15W < 5W Tilt Angle Swivel Angle On Mode Standby Mode POWER MANAGEMENT Suspend Mode Off Mode EnglishEnglish 11 HP 17" Color Monitor User's Guide Care and Cleaning Care and Cleaning Do not place anything on top of the monitor. Doing so may block the monitor vents and cause damage to the monitor due to overheating. Do not let liquid get on or into the monitor. To maximize screen life and prevent damage to the picture tube (such as burned phosphor due to leaving the same image on the screen for a long time), it is recommended that you: Use the monitor power management system (on HP computers) or a screen saver program. · Avoid setting contrast and brightness to their maximum levels for prolonged periods. · If you do not have a power management system or a screen saver program, switch the monitor off or reduce the brightness and contrast to minimum levels when the monitor is not in use. Your monitor has an anti-glare, anti-static screen coating. To prevent damage to the monitor screen's coating, use a regular household glass cleaner when cleaning the screen. To clean the screen: · Switch the monitor off and remove the power plug (pull out the plug, not the cable). [. . . ] The length of time to reactivate the computer shall be reasonable for the user. Labelled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. 18 EnglishEnglish HP 17" Color Monitor User's Guide Regulatory Information Below you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development SE-114 94 Stockholm, Sweden Fax: +46 8 782 92 07 Email (Internet): development@tco. se Current information regarding TCO'99 approved and labelled products may also be obtained via the Internet, using the address: http://www. tco-info. com/ Environmental requirements Flame retardants Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at least to delay the spread of fire. [. . . ]