User manual HP 9000 MODEL 735/99 WORKSTATION

[. . . ] Hewlett­Packard shall not be liable for errors contained herein or direct, indirect, special, incidental, or consequential damages in connection with the furnishing, performance, or use of this material. WARRANTY A copy of the specific warranty terms applicable to your Hewlett­Packard product and replacement parts can be obtained from your local Sales and Service Office. CopyrightE Hewlett­Packard Company 1995 This document contains information which is protected by copyright. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. Restricted Right Legend Use, duplication or disclosure by the U. S. Government Department of Defense is subject to restrictions as set forth in paragraph (b)(3)(ii) of the Rights in Technical Data and Software clause in FAR 52. 227­7013. [. . . ] Table 4­1 shows the Self Test error codes. Table 4­2 shows the PDC error codes. Table 4­3 shows the ISL error codes. Table 4­4 shows the HP­UX kernel error codes. Table 4­5 shows the LED error codes as they appear on the front panel display of Model 715/64, 715/80, , 715/100, and 715/100XC workstations. Use these LED codes to determine the failing component. 4­2 Troubleshooting Table 4­1. Model 715/C, 715/33, 715/50, and 715/75 Self Test LED Error Codes LED Display 8 76543 21 CPU Error - Model 715/33 and 50. CPU Error - Model 715/33 and 50 Motherboard Error - 715/75 CPU Error - Model 715/33 and 50. Loops Until Passes Possible PCX­T Error* FP Register Test Failure. Loops Until Passes Possible PCX­T Error* FP Register Test Failure. Loops Until Passes Possible PCX­T Error* EISA Interface Error. Model 715/C, 715/33, 715/50, and 715/75 ISL LED Codes LED Display 87654321 ISL executing. ISL is autobooting from the Autoexec File. Utility File Header inconsistent: Invalid System ID. Utility File Header inconsistent: Bad Magic Number. Utility requires more Memory than is configured. Incorrect Checksum: Reading Utility into Memory. = LED On or Flashing (Continued) Status 4­8 Troubleshooting Table 4­3. Model 715/C, 715/33, 715/50, and 715/75 ISL LED Codes (Cont. ) LED Display 87654321 System Console needed. Internal inconsistency: Invalid Boot Device Class. Destination Memory Address of Utility is invalid. Internal inconsistency: pdc_cache entry. [. . . ] Removing the Processor Board 5­46 Field Replaceable Units Calendar Battery (Location B1) EEPROM (Location UV17) Power Supply Connector (P6) SCSI Cable Connector (P8) Memory Slots Speaker Connector (P4) Rear Audio Board Connector (P1) EISA Adapter Board Connector (J20) Front Audio Board Connector (P2) CD-ROM Audio Board Connector (P5) (Not all components are shown) Figure 5­46. Component and Internal Connector Locations Model 715/C, 715/33, and 715/50 Field Replaceable Units 5­47 Calendar Power Supply Battery Connector (P7) (Location B1) PC Floppy Connector (J2) SCSI Cable Connector (P3) Reserved Memory Slots Rear Audio Board Connector (P15) GSC EISA Adapter Board Connector Speaker Connector (P13) Front Audio Board Connector (P12) CD-ROM Audio Board Connector (10) (Not all components are shown) Figure 5­47. Component and Internal Connector Locations Model 715/64, 715/80, 715/100, 715/100XC 5­48 Field Replaceable Units Calendar Battery (Location B1) EEPROM (Location UV17) Power Supply Connector (P6) SCSI Cable Connector (P8) Memory Slots Rear Audio Board Connector (P1) PCX­T Board Connector (P9) EISA Adapter Board Connector (J20) Speaker Connector (P4) Front Audio Board Connector (P2) CD-ROM Audio Board Connector (P5) (Not all components are shown) Figure 5­48. Component and Internal Connector Locations 715/75 Field Replaceable Units 5­49 System EEPROM If you are replacing a 715/C, 715/33, 715/50, or 715/75 processor board with a similar board (that is, with any board except a 715/64, 715/80, 715/100, or 715/100XC), remove the EEPROM from the failed processor board and install it in the new/exchange processor board. [. . . ]