User manual HP 9000 MODEL 755/125 WORKSTATION

[. . . ] 3. 25C (Quantum only, not needed for Seagate) Basic: Rev. [. . . ] During the installation procedure, you may have to change the SCSI ID of your disk drive. Refer to the appropriate illustration to set the SCSI ID jumpers to the desired SCSI ID. NOTICE: We recommend that you use SCSI ID 6 for your workstation's first hard disk drive, and SCSI ID 5 for the second hard disk drive. For Series 400 systems, this disk drive is supported at HP-UX release 9. 03 and 9. 10, with patch PHCO_6819 required for full functionality of newfs and sam. The software patches may be obtained from HP Customer Service. To install the patches to HP­UX, perform the following steps: Minimum Software Requirements The 1­GB disk drive is fully operational with HP-UX Release 9. 01 and later on Series 700 systems (releases 9. 01, 9. 03, and 9. 05 require patches to the operating system). On Series 300 and 400 systems, this disk drive is supported only at HP-UX release 9. 03 and 9. 10, and a patch is required to obtain full functionality. For Series 700, type: MICROP_2112 The MICROP_2112 drive is functionally equivalent to the new drives. By using this entry, you can complete the software installation process. 4. Let the software installation process complete. 5. Install the appropriate patch using /etc/update and reboot the system. *A1658-90690* FRONT J6 J2 M S B L S B L S B M S B A0 A1 A2 SCSI ID 0 Term Power from Drive SCSI ID 0 1 2 3 4 5 6 1 2 3 CAUTION Do NOT use the jumper plugs for J2 on J6. [. . . ] Install the appropriate patch using /etc/update and reboot the system. *A1658-90690* FRONT J6 J2 M S B L S B L S B M S B A0 A1 A2 SCSI ID 0 Term Power from Drive SCSI ID 0 1 2 3 4 5 6 1 2 3 CAUTION Do NOT use the jumper plugs for J2 on J6. [. . . ]