User manual HP ARMADA 1500C

[. . . ] [. . . ] The computer will generate only those codes applicable to the actual system configuration and installed options. Common Power-On Messages Table A-1 lists the error messages that may occur when the system is powered-on or reset. Table A-1 Power-On Messages Message 163 - Time and date not set (Two very short beeps) RESUME = "F1" key Beeps 2S 2VS None Probable Cause Invalid time or date Power-on successful Any failure Error Messages A-1 Initialization Diagnostic Messages Table A-2 lists error messages that may occur as part of the Power-On Self-Test (POST). Table A-2 Power-On Self-Test (POST) Messages Message Beeps Probable Cause No visible message 3L Processor Self-test No visible message 2L Memory map failure 101 - I/O ROM error 1L, 1S Option ROM checksum 101 - ROM error 1L, 1S System ROM checksum 102 - System Board Failure None DMA or timers 102 - System or Memory Board Failure None High-order addresses 162 - System Options Error 2S No diskette drives or mismatch in drive types 162 - System Options Not Set 2S System SETUP (Run SETUP) 163 - Time and Date Not Set 2S Invalid time or date in configuration memory 164 - Memory Size Error 2S Memory size discrepancy 170 - Expansion Device not Responding None Expansion device not responding (Run SETUP) 176 - Slot with No Readable ID None Slot with no readable ID (Run SETUP) 177 - SETUP Not Complete None SETUP not complete (Run SETUP) 178 - Processor SETUP Invalid None Processor SETUP invalid (Run SETUP) XXOOOY ZZ 201 - Memory Error None RAM failure XXOOOY ZZ 203 - Memory Error None RAM failure 205 - Cache Memory Failure None System board Z 205 - Memory Failure None Memory board failure 206 - Secondary Cache Controller Failure None Cache Memory Controller Failure 207 - Invalid Memory Configuration None System memory board Z 209 - NCA RAM Error None NCA Failure 211 - Memory Failure None RAM Failure 301 - Keyboard Error None Keyboard failure 301 - Keyboard Error or Test Fixture None Keyboard test fixture Installed 302 - System Unit Security Lock is Locked 2S System locked - Unlock System Unit Security Lock 303 - Keyboard Controller Error None Keyboard controller NOTES: 1. XX000Y ZZ = Address (XX), byte (Y), data bit (ZZ) of failed memory test Continued A-2 Error Messages Table A-2 Power-On Self-Test (POST) Messages Continued Message 304 - Keyboard or System Unit Error 401 - Printer Error 401 - Port 1 Address Assignment Conflict 402 - Monochrome Adapter Failure 403 - Port 3 Address Assignment Conflict 501 - Display Adapter Failure 601 - Diskette Drive Controller Error 602 - Diskette Drive Boot Record Error 605 - Diskette Drive Type Error Beeps None None 2S 1L, 2S 2S 1L, 2S None None 2S Probable Cause Keyboard interface Printer controller External and Internal Port assignments to Port 1 Monochrome display controller External and Internal Port Assignments to Port 1 Graphics display controller Diskette drive controller Diskette drive does not have a valid boot record Wrong drive type used in the computer setup utility Configuration error Configuration error 607 - Diskette Drive Controller Error 2S 611 - Primary Diskette Drive Assignment 2S Conflict 612 - Secondary Diskette Drive 2S Configuration error Assignment Conflict 702 - A-Coprocessor Detection Error 2S Add coprocessor or configuration error 703 - Coprocessor Detection Error 2S Add coprocessor or configuration error 1125 - Internal Serial Port Failure 2S Defective internal serial port 1150 - xx Comm Port Setup Error 2S Setup not correct (run SETUP) 1151 - COM1 Address Assignment 2S External and internal port assignments Conflict to COM1 1152 - COM2 Address Assignment 2S External and internal port assignments Conflict to COM2 1153 - COM3 Address Assignment 2S External and internal port assignments Conflict to COM3 1153 - COM4 Address Assignment 2S External and internal port assignments Conflict to COM4 1600 - 32-Bit System Manager Board 2S Configuration mismatch Failure 1730 - Hard Drive 0 Does Not Support 2S Configuration mismatch DMA Mode 1731 - Hard Drive 1 Does Not Support 2S Configuration mismatch DMA Mode 1740 - Hard Drive 0 Failed Set Block 2S Configuration mismatch Mode Command 1741 - Hard Drive 1 Failed Set Block None Wrong drive type Mode Command 1750 - Hard Drive 0 Failed Identify None Wrong drive type Command 1751 - Hard Drive 0 Failed Identify None Wrong drive type Command NOTES: 1. XX000Y ZZ = Address (XX), byte (Y), data bit (ZZ) of failed memory test Continued Error Messages A-3 Table A-1 Power-On Self-Test (POST) Messages Continued Message Beeps Probable Cause 1760 - Hard Drive 0 Does Not Support 2S Configuration mismatch Block Mode 1761 - Hard Drive 1 Does Not Support 2S Configuration mismatch Block Mode 1771 - Primary Drive Port Address 2S Internal and external hard drive controllers Assignment Conflict assigned to primary address 1772 - Secondary Disk Port Address Internal and external hard drive controllers Assignment Conflict assigned to secondary address 1780 - Hard Drive 0 Failure None Hard drive 0 not ready 1781 - Hard Drive 1 Failure 2S Hard drive 1 not ready 1782 - Hard Drive Controller Failure None Hard drive controller 1790 - Hard Drive 0 Error None Wrong drive type used in SETUP 1791 - Hard Drive 1 Error None Wrong drive type used in SETUP 1792 - Secondary Drive Controller Error None Hard drive error or wrong drive type 1793 - Secondary Controller or Drive None Hard drive error or wrong drive type Failure XX000Y ZZ Parity Check 2 None RAM parity failure Hard Drive Parameter Table or BIOS Error 3L Configuration or hardware failure IOCHECK Active, Slot X None Defective board in slot x Bus Master Time-Out Slot X None Defective board in slot x Audible 1S Power-On successful Audible 2S Power-On successful (RESUME = "F1" KEY) None As indicated to continue NOTES: 1. XX000Y ZZ = Address (XX), byte (Y), data bit (ZZ) of failed memory test A-4 Error Messages Advanced Diagnostics Error Messages The following tables list error messages that may occur during Advanced Diagnostics testing. [. . . ] [. . . ]