User manual HP BLADESYSTEM P-CLASS ENCLOSURE

[. . . ] HP Insight Control Management User Guide HP Part Number: 411803-008 Published: July 2008, Eighth Edition © Copyright 2006, 2008 Hewlett-Packard Development Company, L. P. Legal Notices Confidential computer software. Valid license from HP required for possession, use or copying. Consistent with FAR 12. 211 and 12. 212, Commercial Computer Software, Computer Software Documentation, and Technical Data for Commercial Items are licensed to the U. S. [. . . ] For example, data cannot be logged for a virtual machine guest if not also logged for the connected virtual machine host. IMPORTANT: To monitor, alert, and log virtual machine guests, enable the monitor, alert, and log parameters for the associated virtual machine host. NOTE: The sample rate, log days, and number of samples cannot be set for the virtual machine guests. These values are the same as those of the virtual machine host. Monitoring parameters PMP monitoring can operate in four modes: 1. Monitor - This mode enables server status monitoring, updating information that HP SIM and PMP display. Analysis information and debug performance issues can be viewed using the Online Analysis tool. Monitor & Alert - This mode, in addition to the capabilities enabled with Monitor, sends alerts to HP SIM when the status of a server changes. Monitor, Log, & Alert - This mode, in addition to the capabilities enabled with Monitor & Alert, stores detailed performance information in the PMP database for later reporting or playback, using the Offline Analysis tool. Monitor & Log - This mode enables monitoring of servers and stores the performance information in the PMP database for playback later. 2. 3. 4. When monitoring begins for a server, the alert and log status in the table reflect that the Alert and Log options are chosen. When the monitoring ends, the table shows the previous state of Alert and Log status. The following figure illustrates the details. 1. 4. Row number 1: Monitoring is started, Alert and Log enabled. The results are Started, Tick and Tick in the table. Row number 2: Monitoring, Alert and Log disabled. The results are Blank, Tick and Tick in the table reflecting the previous state of Alert and Log when the monitoring is stopped. Row number 6: Monitoring is started, Alert enabled and Log disabled. The results are Started, Tick and Blank reflecting the current status whenever the monitoring is started. Row number 7: Monitoring, Alert and Log disabled. The results are Blank, Tick and Blank reflecting the previous state of the Alert and Log when the monitoring is stopped. Contrasting the graphical display 121 Number of samples The Number of samples setting enables adjustment of PMP analysis to account for highly variable or stable system performance. A higher number of samples results in smaller average changes in performance. Therefore, it generates fewer performance bottleneck indications for a server whose performance changes significantly. [. . . ] This event can indicate a lack of disk space or permission problems. Vulnerability and Patch Management Pack When one or more reports are not removed failed to remove a results file from the VPM as a part of the delete operation from the results area View Results by System or View Results by Scan Name process. The VPM Patch Agent has been installed When the VPM Patch Agent deploys successfully to a system as part of a licensing operation or the Deploy VPM Patch Agent operation. When the VPM Patch Agent fails to deploy to a system as part of a licensing operation or the Deploy VPM Patch Agent operation. [. . . ]