User manual HP CD-WRITER 9200

[. . . ] HP CD-Writer Plus User's Guide English English Copyright 1999. Hewlett-Packard is a registered trademark of the Hewlett-Packard Company. registered trademarks of Microsoft Corporation. Names of products mentioned herein are used for identification purposes only and may be trademarks and/or registered trademarks of their respective company. 2 Laser Safety This unit employs a laser. [. . . ] HP Disaster Recovery screens will display messages instructing you when to insert the diskettes and CD(s) from your Disaster Recovery Set. Once the Setup portion of the minimal install has been completed, the Disaster Recovery Wizard will appear and guide you through the rest of the recovery process. You should first decide if another recovery method is possible. For example, if the problem appears to be associated with the Windows operating system, such as a corrupt registry, try to recover by following the steps outlined in your Microsoft Windows User's Manual before attempting the following procedures. If you have determined that a harddrive failure has occurred, proceed to Step 2. Replace any damaged hard-drives with comparable drives. In order to recover all of your information, HP Disaster Recovery must have at least as much hard disk space as existed before the drive failure. Insert the Windows NT Workstation Setup Boot Disk (diskette #1 of the DR Set) into into the 3. 5" floppy drive from which your computer boots, and restart your computer. You will be guided through a partial NT installation. 22 Recovering Your Data 4. When prompted, insert Windows NT Workstation Setup Disk #2 into the 3. 5" floppy drive from which your computer boots. . Choose Express Setup (recommended) or Custom Setup from the NT Setup screen. s Express Setup--Should be selected if you do not need to partition any drive(s), or if you are testing your DR Set. Custom Setup--Should be selected if your primary partition needs to be set up, or if your backup device is not located. Also, if the SCSI card your device is attached to is not detected, you will need to go through a Custom Setup with your Controller Card Installation Diskette. Select this option by pressing C on your keyboard. s You should attempt to partition any new drive(s) to the same settings as were set before the drive failure. In order to partition your drive(s), select Custom Setup and follow the instructions on your screen. Only the boot drive and the NT installation drive need to be partitioned at this time. You will be able to partition and format other drives at a later time through the Disk Administrator in the HP Disaster Recovery process. After proceeding through an Express or Custom Setup, you will be prompted to insert the remaining diskettes and CDs from your Disaster Recovery Set. When prompted, insert Windows NT Workstation Setup Disk #3 into the 3. 5" floppy drive from which your computer boots. When prompted, insert your Windows NT installation CD into your CDROM drive. When prompted, insert Windows NT Workstation Setup Disk #4 into the 3. 5" floppy drive from which your computer boots. When Setup has finished copying files to your hard disk, you will be prompted to remove any floppy diskettes and CDs from your drive(s) and restart your computer. [. . . ] Support is provided free of charge during warranty; your only cost is the long-distance charge. A per-incident charge applies after the warranty period. Canada (M-F, 8:00-20:00 Eastern Time) HP Customer Care in English and French 905-206-4663 Europe/Middle East/Africa (M-F, 8:30-18:00 Central European Time) Austria . 0180 52 58 143 Greece (M-F, CET + 1hr) . [. . . ]