User manual HP COMPAQ A1000

[. . . ] 2 One document exit tray--supports the original document when faxing, copying, or scanning is complete. 3 One AC power (electrical) cord--plugs into the rear of the All-In-One to supply electrical power. 4 The telephone cord--plugs into the A1000 telephone line jack. 5 Two ink cartridges--1 color cartridge and 1 black cartridge. [. . . ] A document jam or very long document was scanned. Pressing STOP after document is loaded. 62/87, 21 Enter a fax number before sending a fax. Load the document to be copied before pressing START. Wait for the current fax operation to complete. Open the cover and remove document or jam. Wait for all document(s) in the document input tray to be fed to the document exit tray. Use the A1000 Settings Utility to set up Speed Send numbers. Wait for memory to become available, then try again or Turn Memory XMIT off from SETUP or A1000 Settings Utility. Press START and the A1000 will send completely stored pages. Current and remaining pages will not be sent. Pressing STOP/CLEAR will cancel the job. Faxes will continue to be received to memory (until full). Replace Black ink cartridge to print out received faxes. Replacing the Black ink cartridge and selecting NEW BLACK CARTRIDGE will reset the ink counting system. (Note that if you keep the old cartridge installed and tell the system you have installed new cartridges you may get some more pages printed but you will defeat the ink management system and may lose incoming faxes. ) Sending station should see a transmission error and re-send the fax. "FAX SPEED # ?UNDEFINED" beep warning tone and return to READY state. Display "MEMORY FULL!" and returns to READY state "MEMORY FULL, TO CONTINUE, START " Entered a number of an unassigned Speed Send. Memory Full occurred while scanning the first page of a document. Memory Full occurred after the first page of a document has been scanned into memory. Phone line disconnected while trying to send a fax. STOP key pressed during fax transmission. Smart Ink has determined that the ink cartridge is empty. An incoming FAX has been saved to memory. "NO LINE CONNECTION", beep warning tone and return to READY state. [. . . ] Use this mode if you wish to receive faxes through the computer modem instead of the A1000. Use only if computer modem is providing answering machine functionality. The computer modem will answer the call and the A1000 will listen for fax tones. It will intercept the call if fax tones are detected. [. . . ]