User manual HP COMPAQ A1500

[. . . ] NOTICE 2000 Compaq Computer Corporation COMPAQ and the Compaq logo Registered in U. S. Microsoft and Windows are trademarks of Microsoft Corporation. All other product names mentioned herein may be trademarks or registered trademarks of their respective companies. Compaq shall not be liable for technical or editorial errors or omissions contained herein. [. . . ] Once the Speed Send numbers are set up, you are ready to begin faxing with Speed Send. Load the documents printed side facing down in the document input tray. Press the Options button to select the Speed Send destination or enter the Speed Send number associated with the name desired. NOTE: When you select the Speed Send number, the name associated with the Speed Send number displays in the lower LCD panel. Press Start to fax. To quickly send a fax using the default settings, simply load the documents, enter the fax number or Speed Send number, and press the Fax button. Use Speed Send #70 to send a fax to everyone in your Speed Send list. To send a fax as email, you must have an internet account and connection, a valid email address, and an email program that supports MAPI (such as Microsoft Outlook, Outlook Express, Eudora, etc). Your fax pages will be sent as JPEG images attached to your email. If the PC is not available but the entry has both fax and email addresses, the fax number will be used. If an email only destination exists, you will be asked if you want to send faxes only. Pressing Start will result in transmission of the faxes and the generation of a report that identifies which entries were not faxed. On Hook Dialing (OHD) This feature provides the ability to dial a number, respond to an automated answering system and then receive or send a fax. Because the All-In-One does not have a microphone, you can only listen. For OHD, complete the following procedure: 1. When the LCD panel displays Ready, place documents face down on the document input tray. Press Start/Dial button to simulate lifting the handset. Dial the number just as you would on a standard telephone. Make sure to dial the number carefully. If you make a mistake, press the STOP button and start over. To obtain a printed list of all the Speed Sends available on your system, see "Printing Reports" in the Common Procedures section. Each Speed Send entry can be a fax number, email address or a group made up of any of the Speed Send entries. The display on the control panel indicates the type of Speed Send entry selected. 4. When the called station answers, you can listen to the answering message. A volume control feature is available when you press the Menu button. To change the volume, press the Menu button until Speaker Volume appears, and then use the Options button to select the desired volume. 5. Press Start when you hear the fax tones. [. . . ] Pay particular attention to the plug, electrical outlet, and the point where the cord exits the product. · Protective Attachment Plug In some countries, the product cord set may be equipped with a wall plug having overload protection. If the plug needs to be replaced, be sure the Compaq authorized service provider uses a replacement plug specified by the manufacturer as having the same overload protection as the original plug. 69 · Extension Cord If an extension cord or power strip is used, make sure that the cord or strip is rated for the product and that the total ampere ratings of all products plugged into the extension cord or power strip do not exceed 80% of the extension cord or strip ampere ratings limit. · Overloading Do not overload an electrical outlet, power strip, or convenience receptacle. [. . . ]